Radio Shack | PT-668C | User's Manual | Radio Shack PT-668C User's Manual

COMPACT DISC PLAYER
PT-668C
Precautions
Thank you for purchasing this HI-FI product. Taking time
to read these operating instructions carefully before use
will acquaint you fully with all its features and help
Do not remove the case and bottom panel
Any inspections or adjustments inside the unit
ensure optimum performance.
In order to simplify the explanation illustrations may
may lead to malfunctions and electric shocks.
sometimes differ from the originals.
Do not touch any of the inside parts.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Ventilation warning
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER(OR BACK)
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The normal ventilation of the product shall not
be impeded for intended use.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to alert
Installation precautions
the user to the presence of uninsulated
Do not install the unit in any of the following
“dangerous
locations since this may result in deterioration
voltage”
within
the
product’s
in performance or malfunction:
enclosure that may be of sufficient magnitude to
*
constitute a risk of electric shock to persons.
Locations exposed to direct sunlight or near objects
radiating heat such as heating appliances.
The exclamation point within an equilateral
*
Locations exposed to moisture or humidity.
*
Locations with poor ventilation exposed to dust and
dirt.
triangle is intended to alert the user to the
presence
of
important
operating
and
maintenance (servicing) instructions in the
*
Locations which are unstable and not perfectly flat
or which are susceptible to vibration.
literature accompanying the appliance.
Do not wipe with thinners
WARNING: To prevent fire or shock hazard, do not
Wipe the panels and case from time to time
expose this appliance to rain or moisture
with a soft cloth. Using any kind of thinner,
alcohol or volatile liquid will mar the surface,
cause blotching on the exterior and erase the
Power plug
When disconnecting the power cord from the
markings and should therefore be avoided.
Do not use insecticide sprays in the vicinity.
power outlet, always take hold of the plug, and
not the wire, and pull free. Never connect or
Dripping warning
disconnect the power plug with wet hands
The product shall not be exposed to dripping or splashing
since you may receive an electric shock.
and that no objects filled with liquids, such as vases, shall
Remember to disconnect the power plug from
be placed on the product.
the power outlet when you do not intend to
use the unit for a prolonged period of time.
Panel Information
11 7 8 12 9 10 13
COMPACT DISC PLAYER
RANDOM
INTRO SCAN
MEMORY CLEAR
MEMORY
1.
2.
3.
4.
5.
6.
7.
8.
2
3
ON/STANDBY SWITCH
Press button to switch “ON” the unit. Press again to
switch “OFF” unit into “STANDBY MODE”.
Fast BWD
The player will skip backward when Fast BWD key is
pressed. Continuously pressing this button makes the
player scan through the tracks backward fast.
Fast FWD
The player will skip ahead to the next track each time
the Fast FWD button is pressed. Continuously pressing
this button makes the player scan through the tracks
forward fast.
PLAY/PAUSE
Press PLAY/PAUSE button to play and press it once
again if you wish it to pause. The relative signs will be
shown on display. If in pause mode, press this key once
again to resume the operation.
STOP
Press STOP key to stop playing/fastFWD/fastBWD or
any kinds of such operations.
OPEN/CLOSE
Press the OPEN/CLOSE button. The disc tray will slide
out. When it has opened fully, place a compact disc
carefully in the tray, and press it once to close.
RANDOM
The songs will be playback by random for whole disc
without repeat if you press this key once. And you can
stop it by press stop key.
INTRO
If you desire the introduction scanning, you can press
INTRO button. Then each track will be scanned 10
seconds. An “INTRO” will be shown on the display.
Press it once again can resume the operation, the
relative light will gone off.
4
9.
10.
11.
12.
13.
REPEAT
RESET
STOP
ON / STANDBY
1
DISPLAY
5
OPEN/CLOSE
6
DISPLAY
Press DISPLAY button once, the display will show out
the Track Remain Time. And press once more, Disc
Remain Time will be shown on the Musical Calendar.
Press once again can resume the operation.
REPEAT
Press REPEAT button once, the display will show out
REPEAT 1, then the track which is in play mode or
ready mode will repeat until you switch off the CD
player or press STOP. Press REPEAT button once more,
Repeat ALL will be shown on the display, all track will
be repeated until you switch off the CD player or press
STOP button.
MEMORY CLEAR
MEMORY
Press the MEMORY button at first, the MEMORY and
the corresponding track will be flashed. Then press the
FastFWD or FastBWD to reach your desired track and
press MEMORY button once more to store the first
track. If wishing to store the second track, press the
FastFWD or FastBWD to the second desired track and
press Memory button to store the second track.
Repeat the same procedure to similar settings. Continue
to enter track numbers until all the pre-decided tracks
are stored for playback. Press the STOP upon finishing
programming. Press PLAY button once, the different
tracks that have been stored will be played according to
the memories stored. If you wish to clear all the
memories, please press the OPEN/CLOSE switch once.
RESET
Operating Procedures
OUTPUT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REMOTE SYSTEM
TO AMP
AUD IO
EQ
IN
FM
75 Ω
R EC
AM
P LAY
INTEGRATED CIRCUIT
AC 220V~230V 50Hz
CD
EQ
REMOTE SYSTEM
LO O P
R EC
P LAY
AUX
CD
IN
Operating Procedure
Switch on the Amplifier.
To close the disc tray, press the OPEN/CLOSE button
Select “CD” from function selection column at the
again. When the tray is securely closed the disc will
Amplifier, relative light will be seen when selected.
start turning automatically and the total number of
Turn on the CD player by press the POWER Switch (1).
selections and the total disc time will be counted. A few
Press the OPEN/CLOSE button. The disc tray will slide
seconds later the Play indicator will light, and the
out. When it has opened fully, place a compact disc
TRACK NO. and TIME counter will show “10:00”.
carefully in the tray.
Press the PLAY/PAUSE button. Playback will start, the
**Note**
PLAY indicator “►” will go on.
a). Always place the compact disc in the disc tray with
When playback of the last track is finished, the CD
the label facing upward.
b). The CD tray accepts two different sizes of disc:
120mm & 80mm.
player head will return to the beginning of the first track,
and the TRACK NO and TIME counters will show
“00:00”.
Specifications
Output voltage………………………. 2 Vrms (0dB)
Freq. Response……………………… 20 to 20 Khz
+3dB- -3dB
S/N ration (FLAT)……………..…… 75 dB (1Khz)
Channel Seperation………………… 58 dB (1Khz)
Channel balance…………………… 0.5 dB (1Khz)
Distortion…………………………… (-10dB) 0.08% (1Khz)
Power consumption………. 8W
Dimensions…………………………. W: 430mm
H: 116mm
L: 267mm
Weight……………………………… 3 kg (NW)
3.5kg (GW)
Design and specifications are subject to change without notice.
Download PDF