- Industrial & lab equipment
- Electrical equipment & supplies
- Batteries & accessories
- Rechargeable batteries
- Seidio
- RBT-1000
- Quick guide
advertisement
Seidio Bluetooth GPS Receiver
RBT-1000 Quick Guide
Check the Package Content
Before you start using Seidio Bluetooth GPS Receiver, RBT-1000, please check out if your package includes the following items. If any item is damaged or missed, please contact your reseller at once.
RBT-1000
Power Switch, Power Jack & External Antenna Port
Right View
Power
Switch
Power Jack
External
Antenna Port
English 1
LED Display
Front View
1 2 3 4
Battery Status GPS Status Bluetooth Status
1
2
Yellow LED indicates power is in charging
Blinking red LED indicates low power
3
4
Blinking Green LED indicates position is fixed
Blinking Blue LED indicates Bluetooth is connected
Getting Started
STEP 1: Charge the Battery
Before you use RBT-1000, the battery must be charged for at least four hours.
As RBT-1000 is in charging, the Yellow LED will be lighted up. When the battery is fully charged, the Yellow LED will be turned off.
STEP 2: Turn on Receiver and wait for GPS fix
If the position has not been fixed yet, the Green LED will be still. If the position has been fixed, the Green LED will be blinking.
STEP 3: Connect to Bluetooth-enabled handheld device
1. From your Bluetooth-enabled handheld device, execute Bluetooth application software to search RBT-1000 and then connect it to your
English 2
device. If the connection between your device and RBT-1000 is successful, the Blue LED will be blinking.
2. Select correct bluetooth GPS device which name is BlueGPSXXXXXX
(see picture below).
STEP 4: Connect to your Navigation Software
Install and launch your navigation software in Navigation Software Kit and set
GPS configuration. Select correct COM port subject to the outbound
Bluetooth serial port of your handheld device and correct baud rate depending on your navigation software.
•If you are required to type in pin code during configuration, please key in
“0000”.
How to replace Lithium-ion Battery
1. Open the bolt on the bottom cover of RBT-1000 and take the Lithium-ion battery out.
2. Place new Lithium-ion battery into the room of RBT-1000.
The RBT-1000 Lithium-ion battery is replaceable and rechargeable.
The RBT-1000 Lithium-ion battery can last more than 8 hours in continuous operation mode.
How to use Car Charger to charge your handheld device
Connect car charger into your adapter connector of handheld device.
English 3
Tips
1. Place your RBT-1000 below the windshield without window film for car navigation
2. It is suggested that use RBT-1000 under less shielded environment to ensure better performance.
3. For the first position fix, please make sure your RBT-1000 is not in motion but stationary and in open space so as to shorten the fix time.
English 4
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement