Sony PCG-GRT100 Installation guide

Sony PCG-GRT100 Installation guide
PCG-GRT Series Optical Disk Drive
Replacement Instructions
These easy instructions are intended to guide you through the replacement process.
9 To avoid electric shock please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
9 Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.*
9 Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
9 The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
Step 1. Prepare the Computer.
CAUTION: Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Step 2. Remove the Battery Pack.
Locate the battery door and unlock it.
With your thumbs, pull the battery in
the release direction as shown in the
Place the computer upside down on
a protected surface with the Battery
door facing you.
P/N T99860137
Rev. C
Step 3. Remove completely the
battery pack from the computer and
set aside.
PCG-GRT Series Optical Disk Drive
Replacement Instructions
Step 4. Locate the ODD Bay.
Step 5. Unlock the ODD Latch.
Use your thumb and gently slide the
ODD latch in to release direction.
Firmly grasp the CD/DVD drive and
slide it away from the computer as
Step 8. Reinstall the Battery Pack
and reconnect the AC Adapter.
Return the old ODD Bay to Sony
following the included shipping
Step 7. Install New ODD Bay.
Hold the new ODD Bay by the edges
and align it with the opening. With an
even force slide in the new HDD
Make sure the new ODD Bay is
seating flush on the edge of the
P/N T99860137
Rev. C
Step 6. Gently pull the original
ODD Bay away from the computer
as shown.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF