Sony | TDM-iP10 | User's Manual | Sony TDM-iP10 User's Manual

Getting Started
3-876-237-12(1)
List of parts locations
DIGITAL MEDIA
PORT Adapter
3 Put the iPod into the unit’s connector.
Notes
Operating Instructions
TDM-iP10 (M)
 DIGITAL MEDIA PORT cable
 iPod connector
 Power indicator: Lights up in green while the power
When placing or removing the iPod, handle the iPod in the same
angle as that of the iPod connector on this unit and do not twist or
sway the iPod to prevent connector damage.
Do not carry the unit with an iPod set on the connector. Doing so
may cause a malfunction.
When placing or removing the iPod, brace the unit with one hand
and take care not to press the controls of the iPod by mistake.
To connect/disconnect the unit
To use the unit as a battery charger
is supplied.
To DMPORT jack
© 2008 Sony Corporation
Connect the cable so that both  marks
are aligned.
Printed in China
WARNING
Disposal of Old Electrical & Electronic
Equipment (Applicable in the European
Union and other European countries
with separate collection systems)
On copyrights
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
All other trademarks and registered trademarks are of
their respective holders. In this manual, ™ and ® marks
are not specified.
To remove the iPod Dock Adapter
To remove the DIGITAL MEDIA PORT cable from the DMPORT jack, press
both side buttons.
Connecting
1 Connect the DIGITAL MEDIA PORT cable of this unit
to the DMPORT jack of an AV system. Make sure the
AV system is turned off before connecting.
2 Turn on the AV system with a DMPORT jack
This symbol on the product or on its packaging
indicates that this product shall not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product. The
recycling of materials will help to conserve natural
resources. For more detailed information about recycling
of this product, please contact your local Civic Office,
your household waste disposal service or the shop where
you purchased the product.
You can use the unit as a battery charger. While the
POWER indicator lights up, the battery is charging. The
charging status appears in the iPod display. For details,
see the user’s guide of your iPod.
connected to this unit, and select the DMPORT
function.
Disconnecting
Before disconnecting, turn off the AV system.
To put the iPod into the unit’s connector
1 Choose the iPod Dock Adapter that fits your iPod.
2 Insert the Dock Adapter into the unit.
To remove the iPod Dock Adapter, pull it up
with your fingernail or a flat object using the
slot inside the adapter.
Controlling the iPod
Additional Information
Performing basic operations
Troubleshooting
You can operate your iPod by its control buttons,
the control buttons of a connected AV system with a
DIGITAL MEDIA PORT interface, and the remote
supplied with the AV system.
Should you encounter a problem with your unit, find
your problem in the troubleshooting checklist below
and take the indicated corrective action. If the problem
persists, contact your Sony dealer.
Note that if service personnel changes some parts during
repair, these parts may be retained.
When bringing the system in for repairs, be sure to bring
in the entire system.
This product is a system product, and the entire system is
needed to determine the location requiring repair.
Notes
To use an iPod, refer to the user’s guide of your iPod.
Before disconnecting the iPod, pause playback.
Basic Operations
The following operations are available with the AV
system or the remote.
Press

/
/
/ /ENTER
/
/
/MENU/
DISPLAY/
RETURN/TOOL
MENU
VOLUME +/
To
Start play.
Pause play.
Works much like running your
thumb around the Click Wheel
on the iPod counterclockwise
(clockwise).
Works much like the center button
on the iPod.
Press and release to skip to the next
(previous) song/video or chapter of
audiobook/podcast.
Hold down to fast-rewind (fastforward).
Fast- forward (fast- rewind) play.
Works much like the Menu button
on the iPod.
The remote does not function.
Remove any obstacles.
Point the remote at the AV system’s sensor.
The distance between the remote and the AV system is
too far.
Replace the battery.
Make sure the iPod* is securely connected.
Select the DMPORT function on the AV system.
Turn on and off the AV system.
Video/photo image from the iPod does not
appear on the TV screen.
The unit does not support video output. Even if your
iPod has video/photo capability, you cannot view video
or photo content on the TV or other video devices.
There is no sound.
Check the connections.
Make sure the unit is securely connected.
Make sure the iPod* is securely connected.
Make sure the iPod* is playing music.
Adjusts the volume level.
Notes
Point the remote at the AV system.
Depending on the connected AV system, the operation or buttons
may differ. Refer to the AV system’s operating instructions.
While playing video, you cannot use /. You can fast-rewind
(fast-forward) by holding down /.
To change the volume level, use the volume controls on the
connected AV system or the remote. The volume level does not
change even if adjusted on the iPod.
It may take time to start playback depending on the contents.
It may take time to start playback depending on the
contents.
Compatible iPod models
Precautions
On safety
Should any solid object or liquid fall into the system,
unplug the system and have it checked by qualified
personnel before operating it any further.
On placement
The sound is distorted.
Reduce the volume of the connected AV system.
Set the “EQ” setting of the iPod to “Off ” or “Flat”.
*See “Compatible iPod models”.
iPod touch
iPod nano 3rd
generation
(video)
iPod classic
iPod
nano 2nd
generation
(aluminum)
iPod 5th
generation
(video)
iPod nano 1st
generation
iPod 4th
generation
(color display)
iPod 4th
generation
Do not place the unit in an inclined position.
Do not place the unit in locations where it is;
Extremely hot or cold
Dusty or dirty
Very humid
Subject to vibrations
Subject to direct sunlight.
Use caution when placing the unit on surfaces that
have been specially treated (with wax, oil, polish, etc.)
as staining or discoloration of the surface may result.
On heat buildup
Although the unit heats up during operation, this is not
a malfunction.
Place the unit in a location with adequate ventilation to
prevent heat buildup in the unit.
If you have any questions or problems concerning your
unit, please consult your nearest Sony dealer.
Cleaning the unit
Clean the unit with a soft cloth slightly moistened with
mild detergent solution. Do not use any type of abrasive
pad, scouring powder or solvent such as thinner, benzine
or alcohol.
There is severe hum or noise.
Move the unit away from the source of noise.
The compatible iPod models are as follows. Make
sure your iPod is updated to the latest firmware
version.
Specifications
General
Power requirements:
DC IN: 5 V, 600 mA (via DIGITAL MEDIA PORT)
Dimensions: Approx.  80 × 22(h) mm
Cable length: 0.6 m
Supplied accessories:
iPod Dock Adapters (1set)
Design and specifications are subject to change without notice.
iPod mini
Notes
This unit is designed for iPod only. You can not connect any other
portable audio players.
Sony cannot accept responsibility in the event that data recorded to
iPod is lost or damaged when using an iPod connected to this unit.
This product has been designed specifically to work with iPod and
has been certified to meet Apple performance standards.
TDM-iP10 (M) is not compatible with iPhone.
Download PDF

advertising