mobile air conditioner user manual tps-g5 / tps-g55 / tps

mobile air conditioner user manual tps-g5 / tps-g55 / tps
VERY IMPORTANT
Please read this instruction guide before install and using your
portable type air conditioner unit.
This instruction manual is the universal-purpose version for the units
that you purchase, it might be slightly different from the ones
described in the manual, but it does not affect your proper
MOBILE AIR CONDITIONER
USER MANUAL
TPS-G5 / TPS-G55 / TPS-G555
TPS-G7 / TPS-G777
operations and usage.
CAUTION
1. " PLEASE MAKE SURE THE PRODUCT VENTILATES ALL THE TIME "!
Please make sure the inlet and outlet ventilation is not blocked at all times.
2. Operate this unit on a horizontal surface to avoid water leakage.
3. Do not operate this unit in an explosive or corrosive atmosphere.
4. Operate this unit in an ambient of 35 degree centigrade or less.
5. The heating function of the unit should
be operated in an indoor ambient
temperature between 7℃ and 23℃
6. Clean air filter periodically to enjoy the most efficient cooling.
7. When the unit is shut off, please wait at least 3.5 minutes before restarting
this is to prevent the compressor from being damaged.
8. This unit needs at least 7 Amps of electricity to have its compressor
operational. To avoid the household electricity block out, please do not use
any extension cord for this unit.
9. This unit is for indoor cooling, heating and dehumidifying.
10. When turning on the unit, the fan will operate but the compressor will
start up after the cooling alarm flashes for three minutes
●
In heating function, the heating alarm will flash for 3.5 minutes before
the compressor and fan start up.
1
11. When the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid hazard.
CONGRATULATIONS ON YOUR
SELECTION OF A QUALITY
PORTABLE AIR CONDITIONER
12.In order to dispose the appliance safely, please remove the batteries from the remote
control before scrapping it.
PORTABLE AIR CONDITIONER
13. This appliance is not intended for use by persons (including children) with reduced
standards of modern engineering.
unless they have been given supervision or instruction concerning use of the
Our product not only provides you a remote control to help user operate all the
appliance by a person responsible for their safety. Children should be supervised to
functions easily and conveniently but also has below benefits:
ensure that they do not play with the appliance.
14. The air-conditioner can be connected only to a supply with system impedance
‐ Moves easily from room to room on easy glide castors
‐ No installation required-just plug into any household
no more than 0.219Ω.In case necessary, please consult your supply authority
‐ power outlet
for system impedance information.
‐ Powerful refrigerated air system cools down the ambience
instantly whenever you want.
‐ Dehumidified and filtered air cycle improve breathing
ATTENTION
environments effectively.
For effective heating and cooling functions, please
ensure that the following steps are undertaken:
1)
This Air Conditioner has been designed and manufactured to the highest
physical, sensory or mental capabilities, or lack of experience and knowledge,
Extend the exhaust hose to a length of not more
than 400mm. The exhaust hose must be kept
‐ Besides the remote control, your one touch electronic pad
also provides easy-identifying manual operation.
‐ 24 hour programmable timer that can be used with either the
air conditioning or dehumidification setting
parallel and must not be bent up or down.
‐ Unique sleep control function, dehumidification.
2)
A distance of 500mm minimum must be kept
‐ 220-240 Volt 50Hz operation between the filter side of the unit and wall or any
‐ 1.8 meter cord with plug 3)
other obstacles”.
When this appliance starts to defrost, the word
“DF” will be displayed on the LED
2
3
UNPACKING INSTRUCTIONS 1.
NAME OF THE PARTS Place the unit in the correct upright position before
1.
Control panel
unpacking.
2.
Remote control receiver
2.
Cut the two packing straps.
3.
Cool air outlet
3.
Slide the carton in an upwards motion and it will
4.
Joint tube
release from the base.
5.
Exhaust hose
Lift the unit carefully to make it slides out of the foam
6.
Hot air filter
base.
7.
Hot air inlet
5.
Remove the water tank and take out the exhaust hose as the picture.
8.
Remote control location
6.
Install the exhaust hose on the unit before operating the unit.
4 / Window Kit A
9.
Hot air outlet
10. Filler
11. Cool air filter
12. Cool air inlet
13. Water tank
14. Drain hole
4.
CONTENTS
1 / Air conditioner unit
2 / Remote control
3 / User manual
4
5
CONTROL PANEL & DESCRIPTION OF FUNCTION
5.
L.E.D. DISPLAY The display indicates the current setting temperature or the timer setting. When the set
temperature or the timer is adjusted, the new setting is shown then the display returns the
current set temperature.
※ The display is also used to show error codes should a fault occur, see ERROR
CODES.
6.
SPEED Press to select either LOW, MEDIUM, HIGH or AUTO fan speed.
If "AUTO" is selected (During cooling function),”HIGH” or "MEDIUM" or “LOW" will be
selected automatically according to the difference between setting temperature and
ambient temperature.
Note: In dehumidifying function, this key is invalid because the unit is defined to be low speed in
1.
POWER KEY
7. PROGRAMMABLE TIMER Press to turn unit "ON" or "OFF" 2.
FUNCTION TIMER-ON: The timer-on is used to turn on the unit automatically after the set time is
(TEMP+) TEMPERATURE REGULATION KEY (+) During cooling function:This key raises the preset temperature by 1℃ each time it is
pressed and the maximum limit is 30℃.
During heating function:This key raises the preset temperature by 1℃ each time it is
pressed and the maximum limit is 25℃.
4.
Programmable timer ON/OFF key.
Press this key to select cooling, heating, dehumidifying.
3.
dehumidifying mode.
(TEMP-) TEMPERATURE REGULATION KEY (‐) During cooling function:This key lowers the preset temperature by 1℃ each time it is
pressed and the minimum limit is 17℃.
over.
1. Press the "TIMER" key at stand-by status to set the time you desired.
2. Once the set hour has come to an end, the unit will turn on automatically.
3. Press the "POWER" key before time out, the setting time will be canceled and the
unit will turn on.
4. You can set the function and fan speed while setting the timer.
TIMER-OFF: The timer-off is used to turn off the unit automatically after the setting time
is over.
1. Press the "TIMER" key at operating status to set the time you desired.
During heating function:This key lowers the preset temperature by 1℃ each time and
2. Once the set hour has come to an end, the unit will turn off automatically.
the minimum limit is 15℃.
6
7
3. Press the "POWER" key before the time out, the setting time will be canceled and the
REMOTE CONTROL FUNCTION
unit will turn off.
8. SLEEP CONTROL FUNCTION 1. While in cooling mode, press the SLEEP key to set the temperature. It increases1 ℃
after an hour and at most increases 2 ℃ after 2 hours.
2. While in heating mode, press the SLEEP key to set the temperature. It decreases
1 ℃ after an hour and at most decreases 2 ℃ after 2 hours.
3. Press the SLEEP key again can cancel the setting.
9. ALARM When the water tank is full,"E4" will be displayed on the display panel. To resume
operation, please remove the rubber cap of the drain hose to drain out the water firstly.
The E4 warning will disappear after draining, and then you can restart the unit by
pressing the POWER key.
On/Off switch
Function “MODE” selector
Hourly programming
Automatic fan speed
High fan speed
Medium fan speed
Low fan speed
Night operation selector
Temperature selector
8
9
NOTICE
This unit can evaporate the condensation and distribute through the exhaust hose
automatically.
1.
When the unit is in the cooling function, it does not need the drain pipe installed.
Please make sure that the rubber cap“①” is locked on drain hole, when the unit is
running. 2.
When operating the heating function, the “①” rubber cap on drain hole should be
pulled out and install a proper drain pipe in order to improve the heating effect. 3.
When operating the dehumidifying function, the “①” rubber cap on drain hose
should be pulled out and install a proper drain pipe②. ●Please remove the air exhaust hose, connect a drain hose to the drain hole and lead
the water to the outside in order to intensify dehumidifying capacity. CONDENSER/EVAPORATOR Use a brush attachment with a vacuum cleaner.
Casing
※
Please install a proper drain hose② to drain off water. ※
The water will drop into the water tank if without drain hose. When the water tank is
Wipe with a damp cloth and polish with a soft cloth.
full, "E4" will be displayed on the display panel. Please remove the rubber
To remove the air filter, please follows the arrow direction and pull the
cap“①”of the drain hole to drain out the water first. After the drainage is completed,
please restart the unit and then the unit can operate normally.
filter lightly, and then take out the filter for cleaning.
MAINTENANCE
POWER SUPPLY
PLEASE DISCONNECT THE POWER CORD BEFORE CLEANING.
(1) Confirm the correct power. AIR FILTER
(2) Insert the plug into the outlet firmly In order to prevent any
The air filter located on the left hand side of the unit can be removed,
simply by pulling the frame out
dangerous leakage. (3) Don’t pull power wire by force because it will cause damage to power
wire.
10
11
WINDOW KIT INSTALLATION PLACE FOR USE
(1) Because the machine distributes hot air, please don’t place or
operate in a narrow place.
Install the Exhaust Hose and the Adjustable Window Slider Kit as depicted
in Fig.1 & Fig.1a. (2) In case of dangerous leak, don’t work the machine in a humid place.
(3) Don’t place the machine in a sunlit corner otherwise the unit might
shut down due to the overheat and the color of the machine may
soon fade out.
HELPFUL HINTS
The unit is fitted with a special thermal cut off device.
Please ensure the unit is not placed against objects which will
obstruct air intake e.g. furniture or curtains as this will affect it's
How to enjoy heating function?
A. performance dramatically.
EXHAUST HOSE INSTALLATION
1. Circumrotate the exhaust hose according to the direction as the arrowhead ①
indicates and then make it connect with the unit. 2. Circumrotate the exhaust hose according to the direction as the arrowhead ②
indicates and then the exhaust hose can be took out from the unit.
12
13
SPECIFICATION B. Model No.
TPS-G5 / TPS-G55 / TPS-G555
Power Source
Rated Power(EN60335)
Cooling
Heating
TPS-G7 / TPS-G777
220-240V~50Hz
1153W
967W
1346W
1129W
Cooling Capacity
10000BTU
12000BTU
Heating Capacity
10000BTU
12000BTU
When operating heating function:
Moisture Removed
50liters/day
60liters/day
A. Please take out the exhaust hose and joint in Fig.01 and the finished illustration is
Net Weight
26kg
27.5kg
as Fig.03, fix the hot air outlet on the unit as Fig.05.
Water Tank Capacity
B. Turn the unit around and install the cool air outlet on the unit as Fig.03, rotate the
exhaust hose into the cool air outlet clockwise as Fig.05. Put the exhaust hose
2.4L
Refrigerant
R410A
Dimensions (mm)
330Wx477Dx630H
outside and enjoy the heating function. (CE) N 842/2006: TROUBLE SHOOTING Problem E1 Cause R410A is a kind of fluorinated greenhouse gases covered by
Trouble shooting Contact an electrician for repair
Electrical short on both
the Kyoto Protocol.
Its total global warming potential (GWP) is 1975.
temperature sensor and PCB
E2 Electrical short of temperature
Contact an electrician for repair
sensor copper tube and PCB
other household wastes throughout the EU. To prevent possible
wiring
E4 This marking indicates that this product should not be disposed with
Indicates water tank full or
Indicates water tank full or possibly the
possibly the incorrect wiring of
incorrect wiring of plug
plug
hazards to the environment or human health from uncontrolled waste
disposal, please recycle it to prove the sustainable reuse of material
resources. Please ask return and collection systems or contact the
retailer where the product was purchased to return your used device,
they can recycle products safely.
14
15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement