180-220 watt ite power supplies 63

180-220 watt ite power supplies 63
040-02-402-146-EH-1215.pdf
040-02-402-146-EH-1215
07df031a02162e03df007e999c0015d1
180-220 WATT ITE POWER SUPPLIES
DESCRIPTION
The PUP221 series of AC/DC switching power supplies are
for 180-220 watts of continuous output power. They are
enclosed in a 94V-0 rated plastic case with an IEC320/C14
or IEC320/C6 inlet to mate with interchangeable cord for
world-wide use. All models meet EN55022, EN55024 and
FCC class B emission limits, and comply with UL, cUL, TUV
and CE requirement.
PUP221 SERIES
RoHS
FEATURES












No load power consumption less than 0.21 W
Meet efficiency level Ⅵ
M e e t E n e r g y St a r E P S 2 . 0 / E r P l o t 7
Operating altitude up to 5000 meters
Overvoltage protection (latch)
Short-circuit protection (auto-recovery)
Overpower protection (auto-recovery)
Over temperature protection (latch)
High Efficiency
With PFC circuit
100% burn-in at full rated load
Compliant with RoHS requirements
SAFETY STANDARD APPROVALS
UL 60950-1, CSA C22.2 No. 60950-1
File No. E190414
TÜV EN 60950-1
GENERAL SPECIFICATIONS
INPUT SPECIFICATIONS
Input voltage:
Input frequency:
Input current:
Touch current:
90-264 VAC
47-63 Hz
3 A (rms) for 100 VAC
1.5 A (rms) for 240 VAC
250 μA max. @ 264 VAC, 60 Hz
Hold-up time:
10 ms minimum at 110 VAC or 240 VAC
Efficiency:
91% typical at full load
Power factor:
0.9 minimum @ 230 Vac/50 Hz, Full load
Turn on delay time:
3 s maximum at 110 VAC
Inrush current:
80 A @ 115Vac or 160A @ 230Vac at 25℃
Withstand voltage:
1500 VAC from input to output and ground
cold start
OUTPUT SPECIFICATIONS
Output voltage/current:
Total output power:
Ripple and noise:
Overvoltage protection:
Overcurrent protection:
Temperature coefficient:
Transient response:
MTBF:
See rating chart.
See rating chart.
See rating chart.
Set at 112-160% of its nominal output
voltage.
All models protected to short circuit
conditions
All outputs ±0.04% /℃ maximum
Maximum excursion of 4% or better on all
models, recovering to 1% of final value
within 500 us after a 25% step load
change
EMC Performance
EN55022:
Class B conducted, class B radiated
FCC:
Class B conducted, class B radiated
VCCI:
Class B conducted, class B radiated
EN61000-3-2:
Harmonic distortion, class D
EN61000-3-3:
Line flicker
EN55024
ENVIRONMENTAL SPECIFICATIONS
Operating temperature:
Storage temperature:
Operating humidity:
Storge humidity
500,000 hours at full load at 25℃ ambient,
calculated per SR332
0℃ to +40℃
-20℃ to +80℃
20% to 80% non-condensing
10% to 90% non-condensing
EN61000-4-2:
ESD, ±15 KV air and ±8 KV contact
EN61000-4-3:
Radiated immunity, 3 V/m
EN61000-4-4:
Fast transient/burst, ±1 KV
EN61000-4-5:
Surge, ±1 KV diff., ±2 KV com
EN61000-4-6:
Conducted immunity, 3 Vrms
EN61000-4-8:
Magnetic field immunity, 1 A/m
EN61000-4-11:
Voltage dip immunity, 30% reduction for 500
ms and >95% reduction for 10 ms
63
040-02-402-146-EH-1215.pdf
040-02-402-146-EH-1215
07df031a02162e03df007e999c0015d1
UNIVERSAL INPUT
PUP221 ITE SERIES
OUTPUT VOLTAGE/CURRENT RATING CHART
(1)
Model
PUP221-12
PUP221S-12
PUP221-13-2
PUP221-14
PUP221-18
V1
12V
12V
19V
24V
48V
Minimum
Current
0A
0A
0A
0A
0A
Output
Maximum
Current
15.00 A
15.00 A
11.57 A
9.16 A
4.58 A
Tol.
±5%
±5%
±5%
±5%
±5%
Ripple &
(2)
Noise
350 mV
350 mV
350 mv
350 mv
350 mv
Maximum
Power
180 W
180 W
220 W
220 W
220 W
Average Active
Efficiency (typical)
@ 115 / 230 Vac
90 /91%
90 /91%
91 /92%
91 /92%
91 /92%
NOTES:
1.
PUP221models are equipped with IEC320/C14 inlet, and PUP221S-12 with IEC320/C6 inlet.
2.
Ripple and noise is maximum peak-to-peak voltage value measured at output within 20 MHz bandwidth, at rated line voltage and output load
ranges, and with a 10 μF tantalum capacitor in parallel with a 0.1 μF ceramic capacitor across the output.
MECHANICAL SPECIFICATIONS
NOTES:
1.
Dimensions shown in inches [mm]
2.
Tolerance 0.02 [0.5] maximum
3.
Weight: 1000 grams (2.2 lbs.) approx.
PIN CHART
PIN NO.
1
2
3
4
5
6
Polarity
V1 Return &
AC Ground
V1 Return &
AC Ground
V1 Return &
AC Ground
+V1
+V1
+V1
64
040-02-402-146-EH-1215.pdf
040-02-402-146-EH-1215
07df031a0217130341007f1a9400309e
ANNEX A: L-Bracket and Enclosed Formats of
PU110 series
Unit: inch [mm]
Tolerance: 0.02 [0.5]
SERIES: PU110
65
Headquarter Switzerland:
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone +41 44 877 35 00
[email protected]
Office Germany:
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone +49 89 260 38 47
[email protected]
We are here for you. Addresses and Contacts.
Sales Switzerland & Liechtenstein
Sales International Key Accounts
Postcode 3000 – 9999
Postcode 1000 – 2999
Basil Frei
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Eric Letsch
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Peter Felder
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone + 41 44 877 35 18
Mobile + 41 76 279 37 26
Phone + 41 44 877 35 14
Mobile + 41 76 491 66 70
Phone + 41 44 877 35 05
Mobile + 41 79 406 49 83
[email protected]
[email protected]
[email protected]
Sales Germany
Postcode 00000 – 31999
Postcode 38000 – 39999
Postcode 80000 – 99999
Postcode 32000 – 37999
Postcode 40000 – 79999
Sales Austria
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Gerhard Vetter
Pewatron AG
Fürstenbergstraße 12
D-55422 Bacharach-Medenscheid
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
Phone + 49 674 394 75 75
Mobile + 49 163 762 74 30
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
[email protected]
[email protected]
[email protected]
Pressure Sensors
Gas sensors / Gas sensor modules
Load cells
Linear position sensors
Angle sensors
Philipp Kistler
Phone + 41 44 877 35 03
[email protected]
Thomas Clausen
Phone + 41 44 877 35 13
[email protected]
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Accelerometers
Power supplies
Current sensors
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Drive technology
CH Postcode 5000 – 9999 / DE
Drive technology
CH Postcode 1000 – 4999 / AT / IT / FR
Roman Homa
Mobile + 41 79 444 00 86
[email protected]
Christian Mohrenstecher
Mobile +41 76 444 57 93
[email protected]
Sales Other Countries / Product Management
Competitive sensor & power supply solutions worldwide
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement