RX 19e IM - Blaupunkt

RX 19e IM - Blaupunkt
FM-/AM-Radio mit USB/SD
RX 19e
RX 19e
2
RX 19e
3
RX 19e
4
RX 19e
5
RX 19e
6
RX 19e
7
RX 19e
8
RX 19e
9
RX 19e
10
RX 19e
11
RX 19e
12
RX 19e
13
RX 19e
14
RX 19e
15
RX 19e
16
RX 19e
17
RX 19e
18
RX 19e
19
RX 19e
20
RX 19e
21
RX 19e
22
RX 19e
23
RX 19e
24
RX 19e
Conformity
Model number: RX 19e
Description: FM/AM Radio with USB/SD
Brand name: Blaupunkt
Responsible party: M3 Electronic GmbH
Gutenbergstrasse 5, D-65830 Kriftel. Germany
Hereby, Blaupunkt Competence Center Audio M3 Electronic GmbH, declares that this Class 1
equipment is in compliance with the essential requirement and other relevant provisions of
Directive 1999/5/EC.
Letter of conformity can be obtained from [email protected]
Safety Instructions
1. READ INSTRUCTIONS – All the safety and operating instructions should be read before
appliance's operated.
2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for
future reference.
3. HEED WARNINGS – All warnings on the appliance and in the operating instructions
should be adhered to.
4. FOLLOW INSTRUCTIONS – All operating instructions should be followed.
5. WATER AND MOISTURE – The appliance should not be used near water, for example,
near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in web basement.
6. VENTILATION – The appliance should be situated so that its location or position does
not interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface
that may block the ventilation openings, in a built-in installation, such as a bookcase or
cabinet that may impede the flow of air through the ventilation openings.
7. HEAT – The appliance should be situated away from heat sources such as radiators,
stoves, or other appliances (including amplifiers) that produce heat.
8. POWER SOURCE – the appliance should be connected to power supply only of the type
described in the operating instructions or as marked on the appliance.
9. POWER CORD PROTECTION – power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them.
10. POWER LINES – an outdoor antenna should be located away from power lines.
11. OBJECT AND LIQUID ENTRY – care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings.
25
RX 19e
12. ESD WARNING – the display does not function properly or not reaction to operation
of any the control may due to the electrostatic discharge. Switch off and unplug the set.
Reconnect after a few seconds.
13. DAMAGE REQUIRING SERVICE – the appliance should be serviced by qualified
service personal when: a. the power-supply cord or plug has been damaged. b. Objects
have fallen into, or liquid has been spilled into the appliance enclosure. c. The appliance
has been exposed to rain. d. The appliance has been dropped, or the enclosure damaged.
e. The appliance does not appear to operate normally.
14. SERVICING – the user should not attempt to service the appliance beyond that
described in the user operation instructions. All other servicing should be referred to
qualified service personnel.
15. DO ensure that all electrical connections (including the mains plug, extension leads
and inter-connections between the pieces of equipment) are properly made and in
accordance with the manufacturer's instructions. Switch off and unplug the power before
making or changing connections.
16. Unplug this apparatus during lightning storms or when unused for long periods of
time.
17. Never unplug your radio by pulling on the power cord. Always grasp the plug firmly
and pull straight out from the outlet.
18. DON'T remove any fixed cover as this may expose dangerous voltages.
19. DON'T place hot objects or naked flame sources such as lighted candles or nightlight
on, or close to equipment. High temperatures can melt plastic and lead to fires.
20. DON'T leave equipment switched on when it is unattended unless it is specifically
stated that it is designed for unattended operation. Switch off using the switch on the
equipment and make sure that your family knows how to do this. Special arrangements
may need to be made for infirm or handicapped people.
21. DON'T continue to operate the equipment if you are in any doubt about if it's working
normally or if it's damaged in any way. Switch it off, unplug the mains power and consult
your dealer.
22. REPAIR OR REPLACE all electric service cords that have become frayed or otherwise
damaged immediately. Do not use a cord that shows cracks or abrasion damage along its
length, the plug, or the connector end.
23. DON'T place objects filled with liquids, such as vases on the apparatus.
24. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
25. The mains plug shall remain readily operable.
26
RX 19e
26. Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.
27. The ventilation should not be impeded by covering the ventilation opening with
items such as newspapers, table-cloths, curtains, etc.
28. The batteries should be drawn to the environmental aspects of battery disposal.
27
RX 19e
Power Sources
Rear Panel
Plug the power cord
to wall outlet
AC Power
1. Plug the power cord into an 230V wall outlet.
2. Turn the “VOLUME” knob to right side on the front panel. Then the unit will power
on.
28
RX 19e
Location Of Controls
Top Panel
Rear Panel
Front Panel
1. USB/SD/MMC SELECTOR
2. REPEAT
3. NEXT
4. MP3 LINK
5. STOP
6. BACK
7. PLAY/PAUSE
8. SD INDICATOR
9. USB INTERFACE
10. USB INDICATOR
11. PLAY INDICATOR
12. SD/MMC SLOT
13. ANTENNA
14. POWER CORD
29
15. SPEAKER
16. FUNCTION SELECTOR
17. DIAL POINTER
18. POWER ON/OFF
19. VOLUME CONTROL
20. TUNNING CONTROL
RX 19e
Other Features
MP3 Link
Select MP3 LINK mode to listen to external audio devices (like MP3 players or PC)
connected through the 3,5mm MP3 LINK input on the top of the unit.
1. Use a 3,5mm male-to-male stereo cable to connect any external audio device with
a 3,5mm headphone or line-out jack to the MP3 LINK at the top panel of the unit.
2. Start playback on the external audio device. Adjust unit volume (do not set the
volume too high to avoid distortion).
Auto Switch Standby
1. After playback completed, without any signal given for 5 minutes, the unit will
switch to standby mode automatically.
2. Connect external audio devices to MP3 Link Jack during standby mode, press PLAY
key to resume playback.
Radio Operation
General Operation
1. Power on the unit, extending the telescope antenna to the get good reception.
2. Set the “FUNCTION” selector to “AM” or “FM” mode.
3. Adjust radio frequency to your desired station by using the “TUNING” control.
4. Adjust the “VOLUME” control to the desired level.
Note: If you get noise from radio or want get clear sound, please try to adjust the
antenna or move the radio next window to get better reception.
30
RX 19e
USB Operation
General Operation
Insert USB into USB interface.
Unit start playing from first track.
PLAY/PAUSE
Press Pause to stop playing temporarily.
Press again to resume playback.
NEXT
Press to go to the next track.
BACK
Press to go to the previous track.
STOP
Press to stop all playback.
REPEAT
Press once to repeat one track.
Press again to repeat all.
Press again for repeat album.
Press again for random play.
Remark:
Using a USB extension cable for playing is not recommended. The length of
extension cable should be less than 5cm, otherwise will cause sound intermittence.
Playback
1. Plug or slot in USB device into the port.
2. Set the “FUNCTION” selector to “USB/SD/MMC” mode.
3. Playback will start automatically from the first track.
4. Press the “STOP” button when play finished.
5. Press “PLAY / PAUSE” button again, playback will start from the first track.
6. During Playback, press USB/SD/MMC button on the top panel for interchange of
USB/SD playing.
Remark:
1. USB 2.0 maximum capacity: 8 GB
2. After playback completed, without any signal given for 5 minutes, the unit will
switch to standby mode automatically.
31
RX 19e
SD Operation
General Operation
Insert SD card into SD slot interface.
Unit start playing from first track.
PLAY/PAUSE
Press Pause to stop playing temporarily.
Press again to resume playback.
NEXT
Press to go to the next track.
BACK
Press to go to the previous track.
STOP
Press to stop all playback.
REPEAT
Press once to repeat one track.
Press again to repeat all.
Press again for repeat album.
Press again for random play.
Playback
1. Plug or slot in SD card device into the port.
2. Set the “FUNCTION” selector to “USB/SD/MMC” mode.
3. Playback will start automatically from the first track.
4. Press the “STOP” button when play finished.
5. Press “PLAY / PAUSE” button again, playback will start from the first track.
6. During Playback, press USB/SD/MMC button on the top panel for interchange of
USB/SD playing.
Remark:
1. SD maximum capacity: 8 GB
2. After playback completed, without any signal given for 5 minutes, the unit will
switch to standby mode automatically.
32
RX 19e
Technical Features
General Features
Power Supply: A.C. 220 ~ 240V 50Hz
Maximum Output Power: 14W
Size : 230 x 160 x 130 mm
Radio Section
Frequency Bands: FM 88~108Mhz
AM 540~1600KHz
This symbol on the product or in the instructions means that your electrical and electronic
equipment should be disposed at the end of its life separately from your household waste.
There are separate collection systems for recycling in the EU.
For more information, please contact the local authority or your retailer where you purchased
the product.
All rights reserved by Blaupunkt Competence Center Audio M3 Electronic GmbH. This
material may be reproduced, copied or distributed for personal use only.
33
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement