Speaker Setup for Creative Sound Blaster Live! and Sound Blaster Audigy Cards Your PC comes set up to produce sound through two speakers and, depending on the speakers you have, a subwoofer too. If you have a 4 or 6 (5.1 channel) speaker system, follow these steps to get proper sound from all speakers. Connect all speakers to the correct audio connectors on the subwoofer and the PC. Refer to the manufacturer’s documentation included with your speakers. Important: Speaker setup cannot be changed from the Control Panel. You must select speaker setup in Creative before you select it in InterVideo WinDVD. Filename: s3adsba_compaq.doc Title: Addendum [3-column 1 or 2 pages] Template: HP-Print2K.dot Author: billm Last Saved By: billm Revision #: 2 Page: 1 of 2 Printed: 10/29/02 11:44 AM Speaker Setup in Sound Blaster Live! or Sound Blaster Audigy 1 Click Start on the taskbar. 2 Choose All Programs, Creative, Sound Blaster Live! or Sound Blaster Audigy, and then click Creative AudioHQ. 3 Double-click the Speaker icon. 4 Select either 4 Speakers or 5.1 Speakers from the Speakers drop-down menu. For digital speakers, place a check mark in the Digital Output Only check box. 5 Close the Surround Mixer and AudioHQ windows. Speaker Setup in InterVideo WinDVD 1 Insert a DVD movie into the DVD-ROM drive. If the DVD starts playing automatically, skip to step 4. 2 Click Start on the taskbar. 3 Choose All Programs, InterVideo WinDVD 4, and then click InterVideo WinDVD 4. 4 Right-click in the video window, and then click Setup. 5 Select the Audio tab. 6 Under Audio Speaker Configuration, select either 4 channel (Front L/R and Surround L/R) or 6 channel (5.1 Home Theater) if you have analog speakers. For digital speakers, under Audio Output Configuration select Digital (S/PDIF) out to External Processor. Note: If your system does not include a subwoofer, selecting the Send 0.1 (LFE subwoofer) to speaker/headphones box may enhance the low frequency range of sound. 7 Click Apply, and then click OK. Now sound can be heard properly from all available speakers. Filename: s3adsba_compaq.doc Title: Addendum [3-column 1 or 2 pages] Template: HP-Print2K.dot Author: billm Last Saved By: billm Revision #: 2 Page: 2 of 2 Printed: 10/29/02 11:44 AM Speaker Setup After System Recovery Refer to the section “System Recovery” of the printed documentation included with your PC. After a system recovery, you must reselect your speaker mode in the Sound Blaster Live! or the Sound Blaster Audigy program and in the InterVideo WinDVD program. Keep this information with your printed documentation for future reference.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project