User manual | Dual Band Concurrent Router ESR7750

Dual Band Concurrent Router
2.4GHz / 5GHz
PRODUCT
ESR7750
Dual CPU 600Mbps
11N AP/Router
DESCRIPTION
ESR7750 is a Dual Band Concurrent Wireless 11N Broadband
Router with dual CPU that offers user unprecedented network
performance. WMM support boosts streaming and multimedia
intensive services. It supports 2.4Ghz band under 802.11 b/g/n
mode while providing 5Ghz band to guarantee an interference-free
network access.
Multiple SSID provides advance users to manage multiple users of various needs. TX power control
enables flexible transmission tuning for different installation needs and prevents malicious
eaves-dropping. Isolation, filter, firewall and full coverage of security standards promise a securer
network environment.
Dual CPU operates work simultaneously therefore users can enjoy gaming, music or HD video on 5GHz
band while web-surfing or emailing on 2.4Ghz. It also provides with built-in 4-port full-duplex 10/100 Fast
Switch that allows wired Ethernet for standard PC and other network devices. ESR7750 is definitely the
optimal choice for both SOHO and small business entities.
KEY FEATURES
Ø
2.4Ghz & 5Ghz Dual band concurrent
Ø
WPS button support
Ø
WMM and QoS
Ø
Multiple SSID
Ø
WDS
Ø
Scheduling Power saving
Ø
Speed and Bandwidth monitoring
Ø
Firmware recovery
Ø
Best channel selection
1
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
PACKAGE CONTENT
Ø 1* 802.11n Dual Band Concurrent Router (ESR7750)
Ø 1* 12V/1.25 A Power Adapter
Ø 1*QIG
Technical Specifications
HARDWARE SPECIFICATIONS
MCU
Ralink RT2880 266MHz (BB) +RT2850 (5G RF)
Ralink RT3052 384MHz SoC (BB+RF)
Memory
32MB SDRAM + 16MB SDRAM
Flash
4MB + 2MB
Expansion Slots
N/A
PCB dimension
150mm * 100mm
Physical Interface
l WAN: 1 * 10/100 Fast Ethernet RJ-45
l LAN: 4 * 10/100 Fast Ethernet RJ-45
l Reset Button (5 second for reboot, 5~10 seconds for
reset to factory default )
l Power Jack
l WPS push button (Wi-Fi Protected Setup)
LEDs Status
l Power/ Status
l Internet (WAN)
l LAN1~LAN4 (10/100Mbps)
l WLAN 2.4GHz
l WLAN 5GHz
l WPS
Power
l Power Supply: 200 to 240 VDC ± 10％ (ETSI)
100 to 120 VDC ± 10％ (FCC)
Requirements
l Device: 12V/1.25A
2
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
Ø Front Panel (LED status)
WAN
1 ( Link-> blue on, traffic->blink)
LAN
4 ( Link-> blue on, traffic->blink)
WLAN
2 ( Link-> blue on, traffic->blink)
WPS
1 (Station associate-> blue blinking)
Power/Status
1 ( On-> orange Test/reset default->blink)
WPS
Power
WPS
Internet
WLAN
WLAN
2.4G
5G
1
2
3
4
Ø Rear Panel (Interface)
DC Jack
Rest
LAN 10/100
WAN
3
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
RF SPECIFICATION
Frequency
2.400～2.484 GHz(11b, 11g, 11n), 5G(11a)
Band
Modulation
l OFDM: BPSK, QPSK, 16-QAM, 64-QAM
Technolog
l DBPSK, DQPSK, CCK
y
Operating
Channels
11 for North America, 14 for Japan, 13 for Europe
Wireless
l Operation Mode – AP / Router
Setting
l Wireless Mode – 11a/11b/ 11g /11n
l Channel Selection (Setting varies by Country)
l Channel Bandwidth (Auto, 20Mhz, 40Mhz)
Transmission Rate - 11n only mode,11b/g/n mix mode,11b only mode,11b/g
mode, 11a mode, 11a/b/g/n mix mode
Receive
11b: -91dBm
Sensitivity
11g: -75dBm
(Typical)
11a: -75dBm
11n: -75dBm
4
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
Available
11b: 17dBm
transmit
11g: 14dBm
power
11a: 14dBm
11n: 15dBm
Antenna *4
Peak Gain = 4 dBi
SOFTWARE FEATURES
Ø Router and Gateway
Topology
Infrastructure
Operation Mode
AP/Router
LAN
· Over 26% Power saving (Green technology)
· DHCP Server
· Static Routing Table
· Speed/Bandwidth monitor
WAN
· PPTP
· PPPoE
· Static IP
· DHCP Client
· Clone MAC
Router
· NAT/ NAPT
· Static Routing
· Dynamic Route
· Virtual server mapping
· IP address mapping
· Port Forwarding
· Port Triggering
· ALG(Application Layer Gateway) support (RTP/RTSP, AOL, FTP, ICMP,
WMP/MMS, NetMeeting, SIP)
· DNS Relay
· DDNS
· Time Zone(NTP client)
Firewall
· Blocking Ping
· DoS (Blocking Ping, Port scan, Sync Flood)
· MAC / IP Filtering
· ICMP Blocking
5
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
· SPI (Stateful Packet Inspection)
· DMZ (Demilitarized Zone) Host
· Policy Based Parental Controls
Ø Port Range / Service Filtering
Ø Internet Domain Restriction
Ø Dynamic URL Filtering (OEM subscription service)
VPN
VPN pass-through (PPTP, L2TP, IPSEC)
Wireless
· Isolation
· Multiple SSID
· Output Power Control
· WDS
· Power saving(Green technology)
· 64/128 bit WEP Encryption
· WPA Personal (WPA-PSK using TKIP or AES)
· WPA Enterprise (WPA-EAP using TKIP)
· 802.1x Authenticator
· Hide SSID in beacons
· Wi-Fi Protection Setup (WPS)
· MAC filter
· Best channel selection
QoS
· WMM
· Application base
Ø Priority Queue
Ø Bandwidth Allocation
Ø Management
Smart wizard
Insert Wizard CD and guide user to set up device smoothly
Configuration
Web-based configuration (HTTP)
Firmware
· Via webpage upgrade
Upgrade
· Auto recovery once firmware upgrade fail
Administrator
· Administrator password change
Setting
· Idle time out
Reset Setting
· Reboot
6
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010
· Reset to Factory Default
System
Speed and Bandwidth monitoring
monitoring
Scheduling
· Enable Firewall
· Enable power saving
Easy access
· User can type model name and access the main page.
ENVIRONMENT & PHYSICAL
Temperature Range
0 to 45° C - Operating, -10 to 70 ° C - Storage
Humidity (non-condensing)
15%～95% typical
Dimensions
170mm (L) x 111mm (W) x 26mm (H)
Weight
Around 320g
7
* Theoretical wireless signal rate based on IEEE standard of 802.11a, b, g, n chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
4/28/2010

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project