BL67 electronic module RS232 interface BL67-1RS232 ■ Independent of the type of fieldbus and connection technology used ■ Protection class IP67 ■ LEDs indicate status and diagnostic ■ Electronics galvanically separated from the field level via optocouplers ■ Transmission of serial data via RS232 interface ■ Connection of different devices, such as printers, scanners or bar code readers Functional principle Type designation Ident-No. Ident-No (TUSA) BL67-1RS232 6827181 M6827181 Number of channels Supply voltage Nominal voltage Vi Nominal current from field supply Nominal current from module bus Power dissipation, typical 1 24 VDC 24 VDC ð 50 mA ð 140 mA ð1W Transmission level active (URS1) Transmission level inactive (URSO) Common-mode range (UGL) Transmission signals Data buffer received / sent Connection type Transmission rate Parameters -15 to -3 VDC 3 to 15 VDC -7 to 12 VDC RxD, TxD, RTS, CTS 128/ 64Byte full duplex 300 to 115200 bps transmission rate, diagnostics, data bits, stop bits, XON - character, XOFF - character, parity, flow control 15m isolation of electronics and field level via optocouplers Edition • 2017-09-15T08:32:12+02:00 Cable length Electrical isolation Connection technology M12, M23 Number of diagnostics bytes Number of parameter bytes Number of input bytes Number of output bytes 1 4 8 8 Dimensions (W x L x H) Approvals Operating temperature Storage temperature Relative humidity 32 x 91 x 59mm CE, cULus -40…+70 °C -40…+85 °C 5 to 95 % (internal), Level RH-2, no condensation (at 45 °C storage) acc. to EN 61131 Vibration test Extended vibration resistance - up to 5 g (at 10 to 150 Hz) - up to 20 g (at 10 up to 150 Hz) Shock test Drop and topple Electro-magnetic compatibility Protection class Tightening torque fixing screw 1/4 BL67 electronic modules are plugged on the purely passive base modules which in turn are connected to the field devices. The separation of connection level and electronics simplifies maintenance considerably. Flexibility is enhanced because the user can choose between base modules with different connection technologies. The electronic modules are completely independent of the higher level fieldbus through the use of gateways. for mounting on DIN rail no drilling according to EN 60715, with end bracket for mounting on base plate or machinery Therefore every second module has to be mounted with two screws each. acc. to IEC 68-2-27 acc. to IEC 68-2-31 and free fall to IEC 68-2-32 acc. to EN 61131-2 IP67 0.9…1.2 Nm TURCK Inc. ñ 3000 Campus Drive Minneapolis, MN 55441-2656 ñ Phone: 763-553-7300 ñ Application Support: 1-800-544-7769 ñ Fax 763-553-0708 ñ www.turck.com BL67 electronic module RS232 interface BL67-1RS232 Compatible base modules Type BL67-B-1M12 6827185 1 x M12, 5-pole, female Pin configuration Pin Assignment Comments Shielded cable with unterminated end (example): WAS4.5-5/S57 Ident-No. 8016986 BL67-B-1M12-8 6827193 1 x M12, 8-pole, female Pin Assignment Comments Matching connection cable (for example): BS8181-0 Ident no. 6901004 BL67-B-1M23 6827213 1 x M23, 12-pole, female Pin Assignment Comments Matching connection cable (for example): FW-M23ST12Q-G-LT-ME-XX-10 Ident no. 6604070 BL67-B-1M23-VI 6827290 1 x M23, 12-pole, female Pin Assignment Edition • 2017-09-15T08:32:12+02:00 Comments Additionally with 24 VDC sensor supply. matching connection cable (for example): FW-M23ST12Q-G-LT-ME-XX-10 Ident no. 6604070 2/4 TURCK Inc. ñ 3000 Campus Drive Minneapolis, MN 55441-2656 ñ Phone: 763-553-7300 ñ Application Support: 1-800-544-7769 ñ Fax 763-553-0708 ñ www.turck.com BL67 electronic module RS232 interface BL67-1RS232 LED display LED Color D RED Status Meaning OFF No error message or diagnostics active. ON Failure of module bus communication. Check if more than 2 adjacent electronic modules are pulled. Relevant modules are located between gateway and this module. RED TxD GREEN RxD GREEN RTS GREEN FLASHING (0.5 Hz) Upcoming module diagnostics OFF Data is currently not transferred. ON Data is currently transferred. OFF Data is currently not received. ON Data is currently received. OFF Data transfer of communication partner released by RS232 module. ON The RS232 module stops the data transfer of the communication partner. CTS OFF The communication partner has released the data transfer of the RS232 module. GREEN ON The communication partner has stopped the data transfer of the Edition • 2017-09-15T08:32:12+02:00 RS232 module. 3/4 TURCK Inc. ñ 3000 Campus Drive Minneapolis, MN 55441-2656 ñ Phone: 763-553-7300 ñ Application Support: 1-800-544-7769 ñ Fax 763-553-0708 ñ www.turck.com BL67 electronic module RS232 interface BL67-1RS232 Data mapping DATA BYTE Bit 7 Bit 6 Input n STAT TX_CNT_ACK n+1 Buf Ovfl Frame Err n+2 Data byte 0 n+3 Data byte 1 n+4 Data byte 2 n+4 Data byte 3 n+6 Data byte 4 n+7 Data byte 5 m STATRES m+1 reserved Output m+2 Data byte 0 m+3 Data byte 1 m+4 Data byte 2 m+4 Data byte 3 m+6 Data byte 4 m+7 Data byte 5 Bit 5 Bit 4 Bit 3 RX_CNT HndSh Err RX_CNT_ACK HW Failure Bit 2 Bit 1 Bit 0 RX_BYTE_CNT Prm Err TCX_CNT reserved TX_BYTE_CNT RXBUF TXBUF FLUSH FLUSH n = Offset of input data; depending on extension of station and the corresponding fieldbus. m = Offset of output data; depending on extension of station and the corresponding fieldbus. With PROFIBUS, PROFINET and CANopen, the I/O data of this module is localized within the process data of the whole station via the hardware configuration tool of the fieldbus master. With DeviceNet™, EtherNet/IP™ and Modbus TCP a detailed mapping table can be created with the TURCK configuration tool I/O-ASSISTANT. Note: A software function module is available for simple handling of the serial interfaces (RS232, RS485 and RS422). Such a function module is available for the CoDeSys programmable BL67 gateway and for the S7 PLC systems. The actual sequence of the data of the RSxxx modules in the process data of the higher-level control system may vary from that shown here. The sequence in Edition • 2017-09-15T08:32:12+02:00 Profibus systems is generally the reverse (byte 0 complies with byte 7 etc.). 4/4 TURCK Inc. ñ 3000 Campus Drive Minneapolis, MN 55441-2656 ñ Phone: 763-553-7300 ñ Application Support: 1-800-544-7769 ñ Fax 763-553-0708 ñ www.turck.com
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement