Nicads PDF

Nicads PDF
Professional
Nickel-Cadmium
Products
PAG Powerman Batteries.
12V to 30V 7Ah Battery Packs for Location Lighting.
Power for Location Lighting
The PAG Powerman is a 7Ah Ni-Cd
battery pack designed to provide
a robust and reliable source of
power for hand-held location
lighting. The Powerman is uniquely
styled with many original features.
The outer case is tough, lightweight, and designed with
rounded corners and edges for
comfort during use.
arrangement that comprises an
adjustable shoulder strap
(included) and a waist belt that
features a curved body pad
(available separately). The weight
is distributed evenly as the battery
pack is held firmly but comfortably
against the users side. An anti-slip
device in the body pad prevents
the battery slipping around the
waist belt during use.
Unique Carrying Arrangement
The Powerman is worn rather than
carried, by virtue of a unique
High-Quality Cells
The PAG Powerman contains
specially selected cells of superior
> 30V Powerman
with Body Pad
Model 9353
2
POWERMAN BATTERIES
www.paguk.com
quality which provide excellent
voltage hold-up characteristics
and, therefore, extended run-time.
Protective Features
The PAG Powerman features a red
LED end-of-discharge indicator
which flashes with increasing
rapidity approximately three
minutes prior to the end of
discharge. The battery is protected from over discharge by an
'ODP' circuit. This facility prevents
cell reversal, the most common
cause of premature battery failure.
Model
Voltage Capacity
The circuit is reset by simply
pressing the 'ODP Reset' button
on the top panel (this must be
done prior to charging).
Charging
The Powerman should be fastcharged with PAG ACS chargers,
which extend battery cycle life
beyond anything that can be
achieved using systems of other
manufacturers. PAG 30V AR Series
chargers are recommended for
charging all Powerman batteries.
Connectors
Dimensions
Weight
9339
12.0V
7.0Ah
2 x XLR-4 (M)
166 x 240 x 81mm
4.25kg
9338
13.2V
7.0Ah
2 x XLR-4 (M)
166 x 240 x 81mm
4.50kg
9342
24.0V
7.0Ah
1 x XLR-4 (M)
257 x 240 x 81mm
6.30kg
9330
30.0V
7.0Ah
1 x XLR-4 (M)
257 x 240 x 81mm
7.30kg
9353
PAG Powerman Body Pad
Specifications.
> PAG Powerman Batteries
Output Connectors:
Voltages:
12V & 13.2V Models:
2 x XLR-4 Connectors
Model 9339
12V nominal, (10 cells connected
in series, nominal voltage 1.2V per
cell ).
24V & 30V Models:
1 x XLR-4 Connector
Pin Connections:
XLR-4 pin connections as follows:
Pin 1 Negative (-)
Pin 2 No connection
Pin 3 No connection
Pin 4 Positive (+)
NOTE: other output connectors
are also available, to special
order only.
Construction:
PAG batteries have welded cell
interconnections of low-resistance
nickel strap. The case for these
models is designed to protect the
cells from impact damage. The
pack is non user-serviceable.
Cells:
Premium grade Nickel-Cadmium
sealed rechargeable cylindrical
cells.
Model 9338
13.2V nominal, (11 cells connected
in series, nominal voltage 1.2V per
cell ).
Model 9342
24V nominal, (20 cells connected in
series, nominal voltage 1.2V per
cell ).
Model 9330
30V nominal, (24 cells connected in
series, nominal voltage 1.2V per
cell ).
Capacity:
Nominal capacity of 7 amperehours, measured at the five hour
rate.
Operating Temperature Range:
Optimum discharge efficiency is
achieved within the temperature
range 0ºC to +40ºC.
> 12V and 13.2V Powerman batteries
feature dual XLR-4 (M) output
connectors
> The Powerman Body
Pad Model 9353 is
recommended
for extended
periods of
use
Charge Time:
Charge times will vary depending
on the battery voltage and its
state-of-charge.
Over Discharge Protection:
All models incorporate the PAG
ODP circuit which has been
designed to prevent over-discharge
of the Powerman battery, and thus
extend it’s life. A warning light
flashes with increasing frequency
before the ODP circuit trips.
Thermal Protection:
The output socket becomes
isolated if cell temperature
exceeds 70°C and can be reset
when the temperature falls. Re-set
by pressing the ODP Reset button.
Short Circuit Protection:
The battery is protected against
short circuit and excessive current
loads by means of a 20mm
cartridge type fuse rated T10A
(anti-surge). A spare fuse is
supplied in an additional holder.
Shoulder Strap:
The detachable shoulder strap
supplied has provision for length
adjustment and includes a
moulded shoulder pad.
Body Pad:
The Powerman Body Pad and waist
belt assembly (Model 9353) is
available separately and
recommended for extended
periods of use.
Dimensions (H x W x D):
12V & 13.2V Models:
166 x 240 x 81mm
24V & 30V Models:
257 x 240 x 81mm
Weight:
Model 9339:
Model 9338:
Model 9342:
Model 9330:
4.25kg.
4.50kg
6.30kg
7.30kg
> All Powerman batteries
feature detachable shoulder
straps
> PAG 30V AR Series
chargers are
recommended for
charging all PAG
Powerman batteries
(see Page 9), using
charge adaptor
Model 9449
SPECIFICATIONS
www.paguk.com
3
PAG 12V to 30V Ni-Cd Chargers.
30V AR Series Ni-Cd Battery Chargers.
PAG ACS Charging
The 30V AR Series of microcomputer-controlled fast-chargers
operates under the control of PAG
ACS, the world’s most advanced
charging system. The foremost
achievement of PAG ACS is the
ability to fast-charge, accurately
and safely, Ni-Cd batteries of any
manufacture. PAG ACS does not
require sensors within the battery
pack, the two charging wires carry
all the feedback information
necessary for accurate charge
termination. PAG ACS is so
accurate that it extends the working
life of a battery beyond anything
that can be achieved using other
systems.
Autoranging
The Autoranging (AR) facility adapts
the charge program to sequentially
fast-charge Ni-Cd batteries within
the ranges 12V to 31.2V, 1.7Ah to
10Ah. However, 30V AR Series
chargers are optimised to fastcharge 24V to 30V battery packs or
belts, via front XLR-4 (M) sockets.
A 30V 7Ah Pagbelt IC2 or
Powerman will be fast-charged in
less than two hours.
Recovery Charge
The Recovery Charge program can
be activated to regain capacity
which has been lost as a result of
extended storage or use under
adverse conditions.
Maintenance Charge
This feature monitors the battery
after the main charge program and
automatically maintains it in a state
of full-charge until the battery is
removed from the charger.
Capacity
Charge Time*
2Ah
0.5 hours
4Ah
1.0 hours
6Ah
1.5 hours
7Ah
1.75 hours
Worldwide Operation
30V AR Series chargers incorporate
switch-mode power supply
technology which adjusts
automatically to enable operation
wordwide.
8Ah
2.0 hours
10Ah
2.5 hours
Model:
*These times are approximate
only, and assume the battery is
fully discharged.
Connectors:
Size:
Weight:
9763
PAG AR301
1 x XLR-4 (M)
78 x 142 x 240mm
1.07kg
9765
PAG AR304
4 x XLR-4 (M)
78 x 142 x 240mm
1.07kg
PAG 30V Chargers at a Glance.
4
30V AR SERIES CHARGERS
www.paguk.com
PAG AR301
PAG AR304
24V to 30V Charger
Model 9763
24V to 30V Charger
Model 9765
1 x XLR-4 connector
For Ni-Cd batteries only
4 x XLR-4 connectors
For Ni-Cd batteries only
78 x 142 x 240mm / 1.07kg
78 x 142 x 240mm / 1.07kg
Specifications.
> PAG 30V AR Series Chargers
Battery Connections:
PAG AR301
Model 9763
1 x XLR-4 Connectors
PAG AR304
Model 9765
4 x XLR-4 Connectors
Range of Batteries Charged:
Nickel-Cadmium batteries of
reputable manufacture, having
nominal voltages of between 12V
and 30V, and nominal capacities
of between 1.7Ah and 10Ah.
Main Charging Programs:
Fast-charge program under PAG
ACS microcomputer-control.
Recovery charge program
manually selectable.
Ancillary Charging Programs:
Balancing charge; self-adjusting
maintenance charge (automatically
entered after charging).
Self Test Program:
The microcomputer constantly
monitors the operation of the
charger, which is shut down to a
safe condition should any of the
tests fail.
Input Supply:
100-135V or 180-265V AC, autoselected. Frequency 50Hz to 60Hz.
Maximum power consumption
240W.
Output Protection:
Charger protected against short
circuit, open circuit, excess battery
voltage and reverse battery voltage.
AC Mains Failure Protection:
Should mains failure occur during a
charging program, or whilst the
charger is connected, it will shut
down to a safe condition.
Safety:
Designed to comply with electrical
safety standards EN60335-1 and
EN60335-2-29 Class 2 (double
insulated) UK mains lead fitted with
1" fuse to BS1362 rated 5A.
Operating Temperature Range:
0°C to 40°C (+32°F to +104°F).
Typical Battery Charging Times:
Capacity
2Ah
4Ah
6Ah
7Ah
8Ah
10Ah
Charge Time
0.5 hours
1.0 hours
1.5 hours
1.75 hours
2.0 hours
2.5 hours
These times are approximate
only, and assume that the battery
is fully discharged. Charging
times will be less if battery is
partially charged at the
beginning.
Overall Dimensions (H x W x D):
78 x 142 x 240mm
(3.1" x 5.6" x 9.5")
Weight:
1.07kg (2.35lbs).
General Information.
> Service
> Warranty
A full after-sales support service is provided by PAG throughout a
product’s lifetime, which includes servicing, repairs and technical
advice.
PAG products have earned a reputation throughout the world for
excellence in quality, reliability and performance.
PAG maintains a worldwide network of Authorised Service Centres.
These facilities have a wealth of specialist knowledge, which is the
result of PAG’s 40 years of experience. Using PAG’s Authorised
Service Centres is the only way to ensure the continuation of the
quality standard for which you first chose PAG products.
For servicing outside of the UK contact your nearest PAG Agent via
the PAG website at www.paguk.com
For servicing in the UK contact the PAG Service Department:
Email: [email protected]
Telephone: +44 (0) 20 8543 3131
Address: PAG Ltd.
565 Kingston Road
Raynes Park
London SW20 8SA
United Kingdom
The PAG Warranty reinforces this reputation by guaranteeing each
product for a period of 18 months, unless otherwise stated.
PAG chargers have a 2 year warranty.
Refer to the product Instruction Manual for full warranty terms and
conditions.
> Trademarks
The following are trademarks of PAG Ltd:
‘PAG Professional Broadcast Equipment’, ‘Time Battery’ ‘Power & Time
Display’ ‘SuperPack’ ‘Pagbelt’ ‘PAG ACS’ ‘AR Series 2’ ‘PAG Pulsar’
‘PAG Quasar’ ‘PAG Cube’ ‘PAG iPC’ ‘PAG Freelancer’ ‘PAG Power
Plate’ ‘PAGlok Connector’ ‘Paglight’ ‘Softstart’ ‘PowerArc’ ‘PowerMax’
All third party trademarks are acknowledged as such.
PAG Ltd. retains the right to change the specifications
contained herein without notice
SPECIFICATIONS
www.paguk.com
5
Your Partner in Power
TM
Professional Broadcast Equipment
PAG Ltd.
565 Kingston Road
Raynes Park
London SW20 8SA
United Kingdom
E [email protected]
T +44 (0)20 8543 3131
F +44 (0)20 8540 4116
www.paguk.com
www.pagstore.com
PAG is a UK distributor for Angenieux,
Cartoni, Chrosziel, Tiffen and Transvideo.
© 2009 PAG Ltd.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement