ZyXEL | G-200 | User's Manual | ZyXEL ZyAIR G-200 User's Manual

ZyXEL ZyAIR G-200 User's Manual
ZyAIR G-200
Wireless LAN USB Adapter
Quick Installation Guide
Version 1.00
December 2003
Procedure to View a Product’s Certification(s)
1. Go to www.zyxel.com
2. Select your product from the drop-down list box on the ZyXEL home page to go
to that product's page.
3. Select the certification you wish to view from this page.
1. Installation Requirements
Before installation, make sure you have the following requirements.
•
Pentium II 300MHz or above
•
A minimum of 6 MB available hard disk space
•
A minimum of 32 MB RAM
•
A CD-ROM drive
•
A computer with an available USB port
•
Windows 2000/XP
2. ZyAIR Utility and Hardware Installation
The installation procedures are similar for all supported Windows versions.
Windows XP screen shots are shown unless otherwise specified.
DO NOT connect the ZyAIR at this point.
1. Insert the support CD into the CD-ROM drive on your computer. The CD
auto runs. Otherwise, locate and double-click on setup.exe.
A Welcome screen displays. Click Next.
2
2. Click Next to accept the default file location or click Browse to select an
alternate folder.
3. Click Finish to restart the computer.
4. With a USB cable, connect the ZyAIR to an available USB port on the
computer. The PWR LED turns on if the ZyAIR is properly connected.
5. Windows 2000: If a warning window displays, click Yes.
6. Windows XP: A Found New Hardware Wizard windows displays. Select
Install the software automatically (recommended) and click Next.
7. Windows XP: If a warning window displays, click Continue Anyway.
Then click Finish to complete the installation process.
After you install the ZyAIR Utility and connect the ZyAIR, an icon
appears in the system tray.
If the ZyAIR Utility icon displays, the ZyAIR is installed
properly. Refer to the User’s Guide to configure the ZyAIR.
3
LED Display
PWR LED
LINK LED
The following table describes the LEDs on the ZyAIR.
LED
COLOR
PWR
Green
LINK
Green
STATUS
DESCRIPTION
On
The ZyAIR is receiving power.
Off
The ZyAIR is not receiving power.
On
The ZyAIR has a connection to a wireless LAN.
Blinking
The ZyAIR is receiving or sending data.
Off
The ZyAIR is not connected to a wireless LAN.
4
Troubleshooting
PROBLEM
Windows does not
auto-detect the
ZyAIR.
CORRECTIVE ACTION
Make sure the ZyAIR is connected to the computer USB port
properly and then restart your computer. Check the LEDs on
the ZyAIR.
Perform a hardware scan by clicking Start, Settings, Control
Panel and double-clicking Add/Remove Hardware. (Steps
may vary depending on the version of Windows).
Follow the on-screen instructions to search for the ZyAIR and
install the driver.
Check for possible hardware conflicts. In Windows, click Start,
Settings, Control Panel, System, Hardware and then click
Device Manager. Verify the status of the ZyAIR under Network
Adapter. (Steps may vary depending on the version of
Windows).
Reinstall the driver/utility.
Install the ZyAIR in another computer. If the error persists, you
may have a hardware problem. In this case, you should contact
your local vendor.
5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising