10-40 Watt Adjustable Solar Panel Mounting Bracket

10-40 Watt Adjustable Solar Panel Mounting Bracket
10-40 Watt Adjustable Solar
Panel Mounting Bracket
Mounting Instructions
Step 1:
Step 2:
Attach panel bracket to solar panel.
Start by sliding the panel hangers
at the top of the bracket under the
solar panel frame (A). Be sure to
center the solar panel on the bracket.
Attach panel to bracket with two selftapping screws (included).
Attach post bracket to post with two
3/8” x 4” lag screws (included). Install
with twin bolt holes at top of post bracket
as circled. NOTE: Mount as far above
ground as practical, generally the higher
the better.
B.
A.
Step 3:
Step 4:
90°
75°
60°
A.
45°
A.
B.
30°
B.
A.
15°
0°
Use two bolts to install the channel clamp to bottom of solar panel.
The channel clamp fits between the frame of the solar panel and the
panel bracket with the large flat side facing the solar panel. Bolts
fasten via the slots on the panel bracket.
Attach solar panel and panel bracket to post bracket using bolts
(included). First, fasten the two bolts closest to the post (A). Next,
locate desired angle of panel tilt using the adjustable slot. Reference
holes are in increments of 15°. Once mounting bracket is set at
desired angle, install last two bolts (B) to secure in place.
Step 5:
Slots on the side of the panel bracket are for
mounting the appropriate solar controller.
www.kencove.com 800-536-2683
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement