Radio Controlled Clocks Molded Case

Radio Controlled Clocks Molded Case
Radio Controlled Clocks
Molded Case
®
FEATURES
•
•
•
•
•
•
•
•
•
•
•
•
1 Year Warranty
AA battery movement
Automatic synchronization to WWVB
Time change for ST/DST fully automatic
Stepper motor
Integrated antenna
High speed time setting
Manual time setting backup feature
Impact-resistant plastic case and polycarbonate crystal
Sweep second hand
Double dial mounting available
Battery Booster (optional)
GENERAL
american time™ Radio Controlled clocks with optional Battery Booster, are attractive modern clocks that will complement any
architectural style.
Our Radio Controlled clocks are equipped with miniaturized radio receivers to receive the time signal transmitted by the National
Institute of Standards and Technology (NIST) from Fort Collins, Colorado. The time signal is based on the cesium clock, the most
accurate timekeeping device in the world. The clock will automatically receive and compare the time signal with the time shown
on the clock. In case of a deviation, the clock will automatically correct its time to agree with the time signal. This procedure is
executed eight times a day to keep the clock on time.
DESCRIPTION
The american time™ Radio Controlled clock uses one AA alkaline battery. Optional Battery Booster uses six AA alkaline batteries
and extends maintenance free clock operation for 5+ years. It can be set to any U.S. time zone: PT, MT, CT, ET and be used as a
radio controlled movement. It can also be set manually for areas that have poor signal. Once the time zone is set, pin pulled, and
battery installed, the movement will search for the time signal. Once the signal is received and processed it will do a fast run until
the correct time is achieved. This process can be achieved in as little as 3 minutes with good signal but typically will be achieved
at night when signal strength is greatest. Factors such as weather, structural characteristics and topographical conditions can limit
or interfere with signal reception. We recommend letting your clock search for the signal for at least 72 hours. If the clock hasn’t
corrected it means that it is in a location that cannot receive the signal. Move clock to a different wall and make sure that it is
several feet from electronic/electrical devices or large metal surfaces or objects.
Clocks are provided in round only impact-resistant black plastic cases with shatter-resistant safety crystal and bold, black numerals
and minute markers on a non-yellowing white dial. Stylish hour and minute hands are aluminum with a black finish and a red sweep
hand. Optional bezel colors available.
*Movements may not work in all areas. We suggest a sample clock to make sure they will work for your application.
ORDERING INFORMATION
With Batter Booster Plus®
Part #
E56BAND301
E92BAND201
E93BAND201
Description
12" Round surface
12" Double dial ceiling
12" Double dial wall
Part #
E56BAND301BP
E92BAND201BP
E93BAND201BP
Description
12" Round surface
12" Double dial ceiling
12" Double dial wall
E66BAND301
E63BAND201
E62BAND201
15" Round surface
15" Double dial wall
15" Double dial ceiling
E66BAND301BP
E63BAND201BP
E62BAND201BP
15" Round surface
15" Double dial wall
15" Double dial ceiling
Double dial mounting requires a 4" square electrical box in the wall or ceiling.
Note: Personalized dial option available. Add L to the end of the Part #.
140 3rd St. S, PO Box 707, Dassel, MN 55325
800-328-8996 • american-time.com
Page 1 of 2
PS03017 Rev J
SPECIFICATIONS
Motor Operating voltage Battery life
Setting time after reception Receiving time
Radio signal reception times Hand placement
Signal frequency Sensitivity Flush
mount plastic
Stepper
Normal Operation
1.25vdc to 1.70vdc
Nominal voltage
> 1 Year
Battery 4 Minutes
Antenna 3 – 16 Minutes
Operating temperature
1:00, 3:00, 6:00, & 10:00 (AM & PM)
12:00
Gear alignment
60 kHz Typical torque second hand
≤ 50µVm
1 Step/Sec
1.5vdc
AA alkaline
Built-in
23˚F to 131˚F
(-5ºC to +55ºC)
12:00
≥ 180µNm
Surface
mount plastic
OUTSIDE DIMENSIONS
SURFACE
SIZE A BC
12"131⁄4"21⁄2"NA
15"16" 21⁄2"NA
A
A
DOUBLE DIAL (12" & 15" only)
12"131⁄4" 15"85/8"
15"16" 191⁄4"85/8"
B
B
Wall mount plastic
double dial
Ceiling mount plastic
double dial
B
A
B
A
Plastic double
dial profile
C
At American Time, we continually strive to improve our products to meet our customers’ needs and to provide the best possible value. The above specifications are
believed to be correct, are subject to change without notice and may otherwise vary from the above. Please call if you need verification of any specifications or the
suitability of a particular product for a particular application.
© American Time
140 3rd St. S, PO Box 707, Dassel, MN 55325
800-328-8996 • american-time.com
Page 2 of 2
PS03017 Rev J
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement