Rust-Oleum American Accents | 215191 | Use and Care Manual | Rust-Oleum American Accents 215191 Use and Care Manual

TECHNICAL DATA
AAC-14
AMERICAN ACCENTS
METALLIC LEAFING PENS
.DESCRIPTION AND USES
®
.
.PRODUCT APPLICATION
®
PAINTING CONDITIONS
Rust-Oleum American Accents Metallic Leafing Pens
are designed to decorate and personalize items around
the home such as picture frames, candy jars, vases,
storage bins, greeting cards, candle holders and more.
Use on wood, metal, glass, unglazed ceramic, paperboard
and some plastics. The Metallic Leafing Pen is suitable for
used outdoors on mailboxes, planters and birdhouses.
.PERFORMANCE CHARACTERISTICS





Apply only when air and surface temperatures are above
50-90ºF (10-32ºC) and humidity is below 85% to ensure
proper drying.
DIRECTIONS
Hold cap in place and shake paint pen for 30 seconds.
Twist and remove cap. Lightly depress tip several times on
scrap paper to start paint flow. Recap and shake as
needed. When finished, replace cap tightly and store on
side.
.
Easy to use with excellent coverage
Rich satin finish
Durable and permanent
Special chisel tip for broad or narrow lines
Dries to the touch in 15-30 minutes
.PRODUCTS
SKU (1/3 fl. oz.)
215190
215191
215192
.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 15-30 minutes, dry to handle in 1 hour, and fully
dry in 2-4 hours.
.
Description
Gold Leafing Pen
Silver Leafing Pen
Copper Leafing Pen
CLEAN-UP
Wipe up spills and excess with mineral spirits.
1
Form: GDH-164
Rev.: 090613
TECHNICAL DATA
AMERICAN ACCENTS METALLIC LEAFING PENS
.PHYSICAL PROPERTIES
.
PAINT PEN
Resin Type
Polystyrene
Pigment Type
Varies with color
Solvents
Mineral Spirits
Specific Gravity
1.12
Volatile Organic Compounds
<100 g/l
Recommended Dry Film
Thickness (DFT) per Coat
NA
Practical Coverage at
Recommended DFT (assumes
15% material loss)
Dry Times at
77°F (25°C) and
50% Relative
Humidity
Varies with surface type and porosity
Touch
15-30 minutes
Handle
1 hour
Fully Dry
2-4 hours
Shelf Life
3 years
Flash Point
91ºF (32ºC)
Safety Information
For more information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
An RPM Company
Phone: 877•385•8155
www.rustoleum.com
Form: GDH-164
Rev.: 090613
Download PDF