Alsa Refinish KC-OR Installation guide

Alsa Refinish KC-OR Installation guide
CANDY KILLER CAN
How to Apply (Application Steps)
1 Candies are applied over an existing base coat color, with Silver and metallic s being
the most popular choice. Such as our Nevada Silver Stylin’ Base Coat. (Part number
KC-ASB-02) If your piece is already base coated, you can proceed to step number 12.
2 Always apply paints in a well ventilated area, and wear a NIOSH approved respirator to
avoid breathing any fumes.
3 Prepare and prime your part first. Epoxy primers are best for bare metal, and primer
surfacers are best for plastics, fiberglass, or wood. Some plastics may require an
adhesion promoter but most plastics, like ABS plastic, are fine without adhesion
promoters.
4 Before applying your primer, remove all dirt, grease, oil, salt, and chemical
contaminants, by washing the surface with a commercial detergent, or other suitable
cleaning method.
5 Rinse with fresh water and allow to completely dry.
6 Remove any existing loose paint, or rust, etc, with a wire brush or sand paper.
7 Lightly sand glossy surfaces to create a surface profile for adhesion.
8 Apply your primer to the surface according to the manufacturers specifications for you
particular primer.
9 Let your primer cure according to the manufacturers specifications for your particular
primer, and then lightly scuff that to create a surface profile for adhesion.
10 Apply your base coat color over the primer according to the manufacturers
specifications for your particular base coat, using steady even passes, until you
achieve coverage.
11 Let your base coat cure according to the manufacturers specification for your base
coat, and then lightly scuff that to create a surface profile for adhesion.
12 You are now ready to begin applying the candy coloring over your base coat. Begin
making passes over the surface from about 6-8 inches away, and observe to color as
you do.
13 The more coats of candy color you apply, the DARKER you color will be.
14 One the desired color tone is achieved, STOP, and let the candy color flash (dry to the
touch) for about 15-20 minutes, and then top coat with a good quality clear coat, for
durability and a super deep wet look
15 For truly one of a kind colors…..Other color candies can be applied OVER existing
candy colors, to create custom colors, and unique color tones.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement