Mount Master

Installation Instructions

For use with standard and Insulated Siding

Series mount blocks.

-To be installed prior to siding-

Part No. PAPC8559

CAUTION: All electrical connections must be in accordance with state and local codes, ordinances, and the National Electrical Code. If you are unfamiliar with methods of installing electrical wiring and devices, secure the services of a qualified licensed electrician.

Step 1

Remove the trim ring from the Mount Master Assembly.

See Figure 1 at right.

Figure 1

Step 2

Cut the desired opening in the Mount Master by cutting along the patterns provided on the back of the part. See Figure 2 at right.

Step 3

Center the Mount Master over the outlet box. Be sure to place tape or sealant between the Mount Master and the house. Attach the

Mount Master securely using an 8d nail or equivalent with a minimum of four attachments. See Figure 3 at right. Note: The sheathing on the illustration at right has been removed for clarity. The outlet box should be in contact with the under side of the Mount Master.

ELEC.

BOX

Note: The use of a box extension (supplied by others) may be required by your local or state electrical codes. Alternatively, the box can be repositioned so that it contacts the underside of the mount master.

Note: Common sense, caution and care are factors which cannot be built into any product.

These conditions must be supplied by the person(s) installing the fixture.

Figure 2

BOX

EXTENSION

(IF USED)

MOUNT

MASTER

Figure 3

I-0015

MIPC9075

4-30-07

Step 4

Cut the siding around the Mount Master. Install the siding according to the manufacturer's installation instructions.

See Figure 4 at right.

Step 5

Install the trim ring by locking it into place See

Figure 5 at right.

Step 6

Install the light fixture or electrical device per the manufacturer's installation instructions. Be sure that all electrical product gaskets have the proper sealant. See Figure 6 at right.

Figure 4

Figure 5

Figure 6