MPL-600
MPL-600
The induction loop amplifier has been designed to install a cable loop in a ceiling or floor. This eases hearing for people wearing a hearing aid
with a 'T' switch when they are within the area where the loop is installed.
It has 3 balanced mic/line inputs and 1 100 V line priority input.
CHARACTERISTICS
Induction loop amplifier.
Enables hearing for users with a hearing aid with a 'T' switch when within the area where the loop
is installed.
The loop can be installed in the floor or the ceiling.
Automatic gain control (AGC) or limiter.
Metal loss compensation control.
Fault detection with relay output.
It is possible to add more amplifiers at 0º or 90º
POWER
240 W, 10 A
INPUTS
3 balanced mics/lines, XLR 2.5 mV and 385 mV switchable
1 priority input, 100 V line
OUTPUTS
1 line out, XLR 500 mV
Stereo headphones: 3.5 mm jack
CONTROLS
Tone: bass and treble
Volume: inputs 1 to 3 and general volume
INDICATORS
Input and output level
Loop, AGC, limiter and failure
PHANTOM
48 V in mics 1 to 3, selectable
PRIORITY
Priority input over the rest of inputs through 100 V line
Input 1 through signal level, selectable.
POWER SUPPLY
230 V AC, 500 W
DIMENSIONS
483 x 89 x 380 mm depth. 2U 19' rack
WEIGHT
10.4 kg
ACCESSORIES
Mounts for assembly in 19' rack
© 2014 Copyright by FONESTAR SISTEMAS, S.A.
www.fonestar.com
Página: 1/1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement