177 mm
Part No. 720817001
Side Flue
Centre Line
175 mm
Minimum
Clearance
116mm Dia Minimum
Aperture For Flue Tube
Vertical Flue
Centre Line
177 mm
Boiler Mounting Bracket
Fixing Slots
Stand Off Bracket Fixing Slots
Stand Off
Brackets
Using this template mark the position of the four most
suitable fixing positions for the stand off brackets, flue
hole and any pipework.
Drill the wall 8mm diameter and 50mm to accept the
plugs in the pipe kit supplied with the boiler.
Assemble the two stand off brackets to the wall jig
supplied with the boiler using the M6 screws and nuts
supplied in the stand off kit.
Secure the assembly to the wall with the 4 screws from
the boiler pipe kit, and check that the assembly is level
and square.
Continue with the installation using the extended pipe
tails supplied in the stand off kit.
Refer to the template and installation instructions
supplied with the boiler for details of condensate
discharge pipe runs, flue angle etc.
Wall Jig
Combi Only
Not System
IMPORTANT: For rear flue installations add
40mm to the distance measured from the
outside wall face to the flue elbow to allow
for the depth of the stand off brackets.
5 mm Minimum
Side Clearance
5 mm Minimum
Side Clearance
Profile of
Outercase
Stand Off Bracket Fixing Slots
Condensate
Drain
50 mm 45 mm
200 mm
Recommended
150 mm
Minimum
Clearance
Pressure
Relief
Valve
(15mm)
65 mm
Heating
Flow
(22mm)
65 mm
Hot Water
Outlet
(15mm)
65 mm
Gas
Inlet
(22mm)
65 mm
Cold Water
Inlet
(15mm)
95 mm
30
Heating
Return
(22mm)
Part No. 720817001
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement