none WSSP3 Use and Care Manual
Do not disassemble the motor housing.This pump has NO repairable internal parts, and disassembling may
cause leakage or dangerous electrical wiring conditions. If you have any questions regarding the product, please
call customer service at 1-800-346-7611, 8 a.m. - 5 p.m. (EST), Monday – Friday.
Problem
Pump does not start or run
Possible Cause
Corrective Action
1. Blown fuse
2. Tripped breaker
3. Plug disconnected
4. Corroded plug
5. Thermal overload
6. Motor failed
7. Float switch failed
8. Float switch obstructed
Pump operates but pumps little
to no water
1. Screen blocked
2. Impeller loose on shaft
3. Impeller broken
1. Replace fuse
2. Reset breaker
3. Secure plug
4. Clean plug prongs
5. Unplug for 30 minutes, then plug
in
6. Call 1-800-346-7611
7. Please call us at 1-800-346-7611
for a replacement float switch, or go
to the store where you purchased
this pump to purchase a new float
switch
8. Make sure the float switch has
room to move and is not getting
caught on any obstructions. Make
sure your pit is at least 14 in. wide
1. Clean screen
2. Reassemble impeller
3. Call 1-800-346-7611
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement