advertisement
1 Parts Identifi cation
Stack matching pieces in piles. Using the parts list, locate and count the individual pieces and verify that you have received the correct number of pieces.
If any pieces are missing or replacement parts are required, contact
Gronomics at 1-855-299-6727.
NOTE: It is recommended to place a protective layer between the ground and the pieces during assembly. This will help prevent damage to the pieces.
Modular Rustic Garden Wedge
(34”W x 48”L x 32”H - 18D)
Assembly Instruction
MRGW 34-48
1 2
3 4 5
7
8
6
9
ITEM
1
2
3
4
5
6
7
8
9
10
2
1
4
1
QTY.
4
8
2
2
2
2
PART #
CP41
R4501
ES2613L
ES2013
ES1313
ES0713
SH43
BCR43
R3100
FL3652
Parts List
DESCRIPTION
Corner Post, 3-1/4” x 3-1/4” x 41-1/4”
Front & Back Side Rails, 45” x 5-5/8 x 13/16”
End Side Rails, 26-3/8” x 5-1/2” x 13/16”
End Side Rails, 20-1/4” x 5-1/2” x 13/16”
End Side Rails, 13.7/8” x 4-3/8” x 13/16”
End Side Rails, 7-3/4” x 5-1/2” x 13/16”
Shelves, 43-3/4” x 5-1/2” x 1-3/8”
Bottom Center Rail, 43-3/8” x 2-1/2” x 13/16”
Post Cap, 4-5/8” x 4-5/8” x 1-1/2”
Fabric Liner, 36” x 52”
2 Post Assembly
Place two 3-1/4” x 3-1/4” x 41-1/4” corner posts (Item 1) together as shown.
Repeat procedure for the two remaining corner posts.
1
Packaged & Inspected by: www.gronomics.com East Bethel, MN USA
Date:
Continued
763-753-7374
3 Side Rail Assembly
Install the eight 45” x 5-5/8” side rails (Item 2) into the upper part of the slots between the corner posts and slide down.
2
5 Bottom Center Rail Assembly
Install the 43-3/8” x 2-1/2” bottom center rail (Item 8) with the tapered edges of the rail facing down.
Install the fabric liner into the Garden Wedge.
Soil Capacity: 6.5 Cubic Feet
2
4 End Side Rail Assembly Continued
Install the four end side rails (Item 6, 5, 4 & 3) into the upper part of the slots between the two corner posts and slide down.
Repeat procedure on the opposite end with the four remaining end side rails.
8
6 Shelve Assembly
Install the two 43-3/4” x 5-1/2” shelves (Item 7) onto the side rails on both sides of the Garden Wedge.
7 www.gronomics.com
6
5
4
3
7 Post Cap Assembly
Remove the rubber cap from the post studs.
Align the hole of the 4” x 4” post cap (Item 9) with stud and tighten until the post cap makes contact with the post. Do not overtighten.
9
Stud
East Bethel, MN USA 763-753-7374
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project