Yosemite Home Decor CW97001 Use and Care Manual

FOR THE FOUNTAIN
Thefountainisin-doordecoration.
When you open the package, please check all the parts below and make sure no missing any
part:
1. Fountainbody
2. Waterpump &Transformer
3. LED light
ASSEMBLY:
1.
2.
3.
4.
Place thefountain on alevel.
Connectthewaterpumptothetube, makesuretheyaretight.
Addenoughwaterintothefountain,makethewaterwill just cover thepump.
Switch the plugon an electricalsocket, turn it on. Make sure the fountain willbe running
well.
REMARK:
1. Use a proper power source as indicated on the pump label. Keep the cord away from
hightemperaturesand/orheat sources.
2. Operate with freshwater only. Avoid heavily chlorinated water and water with high PH
liquids. Distilled waterisadvisable.
3. If the waterpumpdoesnot work, pleasecheckyourpower,turnit on again.
4. If the top glass ball does not run well, please turn off the power, make sure the fountain
isona levelsurface,andtheball isclean.Then replaceitturnonthe power.
5. Beforeusingthefountain,pleasereadmanualforthesubmersible pump.
RATINGS
1. adaptor
- model:JBA35V-12-250
- Inputforadapter: 230-240V50Hz
- Outputfor adapter:12 V50Hz,250 mA
2. pump:
- model: AP-333LV
- input:12V50Hz2.5 W
CorrectDisposalofthisproduct
-This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources.Toreturnyouruseddevice,pleaseusethereturnandcollectionsystemsorcontactthe
retailer where the product was purchased. They can take this product for environmental safe
recycling.