Total Pond A16531 Use and Care Manual

CARE AND MAINTENANCE
• Regular cleaning of the pump may be necessary depending upon the environment in which it is
operated. Clean the pump when it is visibly soiled or when a drop in performance is detected.
• Before cleaning, always disconnect the pump from the power source.
• Remove all parts from the pump and clean in warm, soapy water.
• Disassemble the front cover and remove the impeller cover to expose the impeller assembly. Use
a soft cloth or brush to clean the impeller assembly and the inside of the impeller housing. Refer to
the diagram in the replacement parts list.
TROUBLESHOOTING
If the pump fails to operate:
• Check to make sure the power cord is plugged in and the pump is getting power.
• Check the pump outlet and any tubing, fountains, spitters etc. for kinks or obstructions.
• Remove the inlet screen and/or front cover, and impeller cover to expose the impeller. Turn the
impeller to ensure that it is not broken or jammed.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the impeller housing are clean.
• Adjust flow control.
REPLACEMENT PARTS LIST
For replacement parts, call our customer service department
at 1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday.
Part
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Description
Pump
Base plate
Filter block
Filter cover
Extension tubes
Waterspray nozzle
Waterbell nozzle insert
Trumpet nozzle insert
lower fountain head nozzle
Adapter
Flow control knob
Front cover
Impeller cover
Impeller assembly
A
B
D
E
C
I
G
H
F
J
N
M
L
K
Printed in China
5