Victor | M325 | Instructions / Assembly | Victor M325 Instructions / Assembly

Easy Set® Mouse Trap
1. Release the arm bar from the staple.
2. Move the arm bar to the back of the trap so it
hangs over the back of the trap.
3. Apply a small amount of peanut butter or
anything high in protein like chocolate or
hazelnut spread to the yellow pedal on the trap
as shown. Be sure to use a Q-tip, toothpick
or another tool to bait so your scent is not
transferred onto the trap.
6. Place the trap where you have seen signs of
rodent activity or along the wall where rodents
primarily travel. The end of the trap where the
yellow pedal is baited should be placed flush
against the wall.
7. After the mouse is caught, properly dispose
of the dead rodent. The trap can either be
discarded or reused.
4. Pull the kill bar back and hold in place with
your thumb.
5. Take the arm bar over the kill bar and latch
the end of the arm bar under the yellow pedal.
Please take note to the Firm and Sensitive
setting. The trap will be easier to set on the
firm side, but not trip as easily. The trap will be
more difficult to set on the sensitive side and
trip very easily.
Download PDF