vg-series vertical lift gate mounting tips c

vg-series vertical lift gate mounting tips c
VG-SERIES VERTICAL LIFT GATE
MOUNTING TIPS
2002 Karbach St. Houston, TX 77092
Toll Free: 800-962-6111
www.safetypg.com
BY:
Paul Boyum
P/N: 190158
DATE:
21 December 2016
ECO: TX-00026
Page 1 of 1
REVISION:
C
The Fabenco VG-Series Vertical Lift Gate provides protection in areas that do not have adequate swing clearance.
Custom gas struts allow the gate to open easily. Tapered guides on the receiver post allow ease of alignment when
closing. Applications include staircase, ladder, and platform openings.
Step 1: Position the vertical lift gate in the closed position and latch it into the receiver post. Position the
assembly into the approximate position at the edge of the opening.
Step 2: Align the edge of the receiver post to be flush with the edge of the opening. Move the receiver post and
vertical lift gate far enough away from the wall to avoid interference when the gate is opened. See illustration
above. The gap between the vertical lift gate and the wall of the opening must not be wide enough to permit a
person to pass through.
Step 3: Once accurately positioned, mark the position of the mounting plate holes on the floor. The posts have
holes to accept ½” diameter anchors or fasteners. The fastening hardware is not provided by Fabenco, Inc.
ANNUAL INSPECTION PROCEDURE
•
•
Verify that all fasteners are tightened.
• Replace any missing fasteners.
Inspect product for any damage. Replace if damage is found.
THE INFORMATION CONTAINED IN THIS DOCUMENT IS THE SOLE PROPERTY OF FABENCO, INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF
FABENCO, INC. IS PROHIBITED.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement