Solarrific G3033 Use and Care Manual

®
FLOATING SOLAR FOUNTAIN – G3033
Features:
No electric outlet or battery needed. This product floats on the
water and starts pumping water soon after bright sunlight shines
directly on the solar cells. It is an energy-saving solar fountain
suitable for garden decoration, bird bath, small pond, water
circulation for oxygen. Installation is simple, easy to use, as long
as there is direct sunlight on the solar cells without shadows,
water pump will start working in a few seconds.
Product Specifications:
Solar Cell Power: 1.4W.
DC Brushless Pump Power: 0.8W.
Product Dimensions: Diameter 6.3in (160mm)
Product Performance:
Maximum Water Coverage: 32 in. (80cm) in Diameter
Maximum Water Height: 18 in. (45cm)
Maximum Flow Rate: 46 gallon / h (175L / h)
Easy assembly
Product Lifespan: 10,000 hours.
The pump will start automatically in 3 seconds when bright sunlight shines on solar
cells directly without any shade or shadow.
Note:
1. The pump of this product is driven directly by sunlight and there is no energy
storage in the battery. The height of fountain water depends entirely on the
strength of the sunlight. When the sunlight is weak, the pump will not work
continuously, but will pump continuously when the sunlight reaches a certain
high intensive brightness. Therefore, the product works best by placing it in an
unobstructed sunlight area. Shade and shadows will affect and lower the pump
performance.
2. Pump must be completely immersed in water. Dehydration on the pump will
shorten the product lifespan.
Assembly for alternate heads
3. Keep the water clean and clean the pump regularly. If it’s dirty,
it will stop the pump from working.
4. To clean the pump, gently first remove the grid cap and black round cap
then pull the white spindle out, once you see debris on the caps, spindle
and hole, rinse them with clean water.
SEE OVER FOR USEFUL TIPS
UPC 811594 01333 4
©2012 Solarrific, Inc.
Solarrific, Inc.
Whitestone, NY 11357 email: info@solarrific.com www.solarrific.com
Toll Free: 866-6solarr (866-676-5277) • Phone: 718-767-5165 • Fax: 718-767-5166
®
Birdbath not included
FLOATING SOLAR FOUNTAIN – G3033
Useful Tips:
Easy assembly
1. Please just put the main unit in the water under direct sun light and it's ready
to go.
2. If the water shoots up too high, you can remove the cap on the spout. If you
have a much larger birdbath in diameter, then you can try other attachments for
different water shapes. Be sure to remove the existing cap before putting other
nozzles.
3. If your birdbath is deep and has a smooth bottom, you can use the big suction
cup and string to stabilize the fountain. First tie one end of string around the
pump and the other end to the suction cup. Be sure that the length between the
pump and the suction cup is about 3" shorter than the height of the water. Press
the suction cup securely on the bottom of the birdbath, so that the fountain is in
the center.
4. If your birdbath has a rough bottom, you can use some pebbles to surround the
pump to make it stable, so that it doesn't flow around too freely.
5. Of course, if you have any further question, you're always welcome to call us at
718-767-5165.
Assembly for alternate heads
We wish you would enjoy our product and we hope you would like us on Facebook
and follow us on Twitter. Thank you!
UPC 811594 01333 4
©2012 Solarrific, Inc.
Solarrific, Inc.
Whitestone, NY 11357 email: info@solarrific.com www.solarrific.com
Toll Free: 866-6solarr (866-676-5277) • Phone: 718-767-5165 • Fax: 718-767-5166