none 5715F4S Instructions / Assembly

5715F4 SET UP INSTRUCTIONS
1) Prepare a suitable location for your new
fountain. The fountain should sit on a
firm and level pad.
2) Always follow local electrical codes,
making sure to connect to a safe GFCI
circuit.
3) Set the 7716H Pedestal on your
chosen location, making sure to face the
side with the power cord notch underneath
toward your power supply.
4) Set the 6716BH Bottom Bowl on the
Pedestal.
5) Place the pump in the Bottom Bowl.
Push the pump power cord down through
the hole in the Bowl and pull it out from
under the Pedestal, toward your power
supply. Then, place the rubber stopper
with the cord size hole around the power
cord (just a few inches from the pump)
and push the stopper tightly into the
bowl’s hole to make the bowl water tight.
6) Thread the barbed adapter into the top
of the pump. Push one end of the ¾”
tubing onto the barbed adapter.
7) Set the 6716AH Middle Bowl in place
on the 6716BH Bottom Bowl, pulling the
excess tubing up through the center hole
as you go. Then, place the other rubber
stopper around the tubing and press the stopper tightly in place.
8) Place the 5715AH Finial on top of the Middle Bowl, pushing the tubing up inside of the Finial.
9) Read your pump instructions.
10) Fill the bottom bowl. Then plug the pump in to enjoy your fountain. If the pump does not
immediately begin working, there may be an “airlock” within the impeller chamber. Simply
unplug and plug in a few times and it should start.
11) If you find that the pump provides too much water action, you may reduce the flow by pulling
the tube further down in the Finial.
12) Save this instruction and make sure to winterize according to details below.
csd
IMPORTANT – WINTER CARE
Winter ice build-up can cause damage to concrete statuary. Follow these tips to reduce winter weathering to your
fountain:
* Disconnect power to pumps.
* Remove adapter from bottom bowl to open drains and let all moisture out. Keep drains open throughout winter.
* Place an absorbant material like burlap, blankets, etc. inside vases/bowls and cover all with a Henri fountain cover.
* Do not allow snow or ice to build up on or against the concrete. Remove snow before it turns to ice. Do not use salt
or chemical ice removers as these may damage concrete.
By following these simple and sensible precautions during the winter season, you will protect your fountain for years of
beauty and enjoyment.