Sea gull lighting | 75435-962 | Installation guide | Sea Gull Lighting 75435-962 Installation Guide

HC-1491
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
IMPORTANT SAFETY INSTRUCTIONS
•
•
•
•
•
•
•
Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
If you are unclear as to how to proceed, contact a qualified
electrician.
You don’t need special tools to install this fixture.
Be sure to follow the steps in the order given.
Read instructions carefully.
Save these instructions.
IF SUPPLY WIRES ARE LOCATED WITHIN 3" OF BALLAST, USE WIRE
RATED FOR AT LEAST 90˚C.
112108
*SUPPLY
GROUND WIRE
*OUTLET BOX
*OUTLET BOX
SCREWS
MOUNTING
BAR (A)
FIXTURE
MOUNTING
SCREWS (B)
GREEN GROUNDING
SCREW (D)
*WIRE
CONNECTORS
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
FIXTURE
GROUND WIRE
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
CANOPY (E)
CAP NUTS
(E)
BEFORE YOU BEGIN
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
INSTALLATION
STEP 1:
Secure mounting bar (A) to outlet box with outlet box screws
(not supplied).
STEP 2:
A. Use a listed wire connector to connect the fixture hot wire (black
wire, or round and smooth tracer) to the supply hot wire.
B. Use a listed wire connector to connect the fixture common wire
(white wire, or square and rigid) to the supply common wire.
C. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do the wiring connection.
STEP 3:
GROUNDING INSTRUCTIONS: The green grounding screw (D) is to
be inserted into the hole with two raised dimples provided on the
mounting bar (A). Wrap the ground wire from the fixture (if supplied)
and the ground wire from the outlet box (bare metal or green
insulated wire) around the green grounding screw (D) on the
mounting bar (A). If uninsulated ground wire is on the mounting bar,
connect the ground wire from the fixture (if supplied) and the outlet
box to it using a small wire connector (not supplied).
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
DIFFUSER (F)
FIGURE 1
*NOT SUPPLIED
FINAL ASSEMBLY
Make sure no bare wires can be seen outside wire connectors.
STEP 4:
After wires are connected, tuck them carefully inside outlet box.
Raise the canopy (G) to the ceiling so mounting screws (B) protrude
through holes in canopy (G). Secure in place by threading cap nuts
(E) onto mounting screws (B).
STEP 5:
Install lamps (not supplied).
STEP 6:
Raise diffuser (F) to canopy (E) and twist into place to secure.
Download PDF