Sea Gull Lighting 78136-08 Installation Guide

HC-1568
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
071409
IMPORTANT SAFETY INSTRUCTIONS
•
•
•
•
•
•
•
Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
If you are unclear as to how to proceed, contact a qualified
electrician.
You don’t need special tools to install this fixture.
Be sure to follow the steps in the order given.
Read instructions carefully.
Save these instructions.
*OUTLET BOX
MOUNTING
BAR (A)
NOTE: FOR FIXTURES PROVIDED WITH 75˚C OR 90˚C SUPPLY WIRE
(FOUND ON CARTON LABEL) WARNING ONLY: RISK OF FIRE. MOST
DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60˚C.
CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING.
GREEN
GROUNDING
SCREW (D)
CLEANING
FIXTURE
MOUNTING
SCREWS (B)
CANOPY (E)
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
*OUTLET BOX
SCREWS
KEYSLOTS (C)
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
CENTER
PIPE (G)
BEFORE YOU BEGIN
Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
DIFFUSER
(H)
INSTALLATION
IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX
FINIAL (D)
WITHOUT THE USE OF A MOUNTING BAR.
STEP 1:
Thread fixture mounting screws BI) into threaded holes of mounting
bar (A) 3 turns each.
STEP 2:
Secure mounting bar (A) to outlet box with outlet box screws (not
supplied). Raised side is top as illustrated.
STEP 3:
A. Use a listed wire connector to connect the fixture hot wire (black
wire, or round and smooth tracer) to the supply hot wire.
B. Use a listed wire connector to connect the fixture common wire
(white wire, or square and rigid) to the supply common wire.
C. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do the wiring connection.
FIGURE 1
*NOT SUPPLIED
INSTALLATION (continued)
HC-1568
STEP 4:
GROUNDING INSTRUCTIONS:
Connect the supply ground wire, fixture ground wire, and mounting
bar ground wire (pre attached) using the supplied wiring connector.
Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do the wiring connection.
FINAL ASSEMBLY
STEP 5:
After wires are connected, tuck them carefully inside outlet box.
Raise the canopy (E) to the ceiling allowing for mounting screws (B)
to protrude through key slots (C). Rotate canopy (E) clockwise until
screws (B) are in narrow part of keyslot (C). Tighten mounting screws
(B) with screwdriver.
STEP 6:
Install lamps.
STEP 7:
Raise diffuser (H) to canopy so that center pipe (G) protrudes through
diffuser (H). Secure in place by threading finial (D) to center pipe (G).