The great outdoors by Minka Lavery | 8988-66 | Installation guide | the great outdoors by Minka Lavery 8988-66 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8988
READ AND SAVE THESE INSTRUCTIONS
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
Fig. 1
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur) and remove the old fixture including
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Separate back plate (M) from cage (L) and remove
cap nuts (G).
4. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) (Part#A-020) spaced the same
distance apart as the holes in the back plate (M),
then tighten with the hex nut (E). Note: The length
of studs (B) into circular strap (C) may be adjusted if
necessary.
5. Attach circular strap (C) (Part#A-020) using
mounting screws (F) (Part#8/32”*1”L) to the outlet
box (A) (Fig 1).
CONNECTION THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in
Fig.2.Making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw
(D) (Part#8/32”*1/3”L) provided.
Fig.2
HOUSE
WI RES
BLACK
( HOT)
FINISHING THE INSTALLATION (Fig.1)
7. Place the back plate (M) onto stud (B) and secure
with cap nuts (G). (Fig 1)
8. Install 1*100W A bulb in accordance with the fixture
specification.—DO NOT EXCEED THE MAXIMUM
WATTAGE
RATING!
(NOTE:
NO
BULB
INCLUDED) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
9. Align cage (L) to back plate (M). Place the rubber
washer (K) on the top of cage (L), then insert nipple
(I) with hex nut (J) into the hole of the cage and
secure with finial (H)
10. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to
outline the outside of fixture back plate (M) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape. (Fig 3)
Your installation is now complete. Return power to the
outlet box and test the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
Fig 3
Caulking
Backplate
Download PDF