Hampton Bay | ES0746BN | Installation guide | Hampton Bay ES0746BN Installation Guide

Pendant Light
Instruction Manual
Please read carefully and save these instructions, as you may need them at a later date.
SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER
THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF
USING THE LIGHT SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible
conditions or situations that may occur. It must be understood that common sense, caution, and care, are
factors which cannot be built into any product. These factors must be supplied by the person(s) installing this
unit.
READ & SAVE THESE INSTRUCTIONS
CAUTION: Before assembling the lighting fixture, refer to the section titled Wiring Connections. If you feel you
do not have enough electrical wiring experience, either refer to a do-it–yourself wiring handbook or have your
lighting fixture installed by a qualified, licensed electrician.
UNPACK THE PACKAGE
Check the contents to be sure everything is included
Tools Needed: Slotted screwdriver, Adjustable wrench, Step ladder, Wire cutters, wiring supplies as required
by electrical code.
INSTALLATION & OPERATION INSTRUCTIONS
GENERAL
Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the
appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical
shock.
All electrical connections must be in accordance with local and National Electrical Code (NEC) standards. If you
are unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.
Remove the fixture and the mounting packages from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
Be sure to read these installation instructions and review the diagrams thoroughly before installation.
Assembly and Installation
1. Screw Tube B (13) into Tube A (12) until secure.
2. Make sure all the electrical is power off, and then attach the mounting plate (4) to the junction
box (1) with the provided machine screws (8).
3. Attach the ground wire (3) under and around the ground screw (5) marked “GND”, and tighten
the ground screw (5) to the ground wire (3) until secure. Connect black/smooth fixture wire to
black supply wire and white/ribbed fixture wire to the white supply wire using wire connectors
(2) provided.
4. Place the canopy (9) to cover into the 2 mounting screws (7) and attach to ceiling by tightening
the Finials (11).
5. Place the shade (15) onto the socket (14) and secure by tightening the socket ring (16).
6. Install bulb (17) into the socket (14).
ELECTRICAL CONNECTIONS
Required Supply Circuit: 120V, 60Hz
Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the black wire(s) from the fixture
to the black wire of the supply circuit. Connect the green or bare copper wire to the ground wire of the supply circuit. Use
UL/CSA listed wire connectors suitable for the size type, and number of conductors. No loose strands or loose wires
should be present. Secure wire connectors with UL/CSA listed electrical tape.
1. Junction box
2. Wire connector
3. Ground wire
4. Mounting Plate
5. Ground screw
6. Fixture Wire
7. Mounting Screw
8. Machine Screw
9. Hexagonal Screw
10. Canopy
11. Finial
12. Tube A
13. Tube B
14. Socket
15. Shade
16. Socket Ring
17. Bulb
Download PDF