The great outdoors by Minka Lavery | 72171-189 | Instructions / Assembly | the great outdoors by Minka Lavery 72171-189 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72171-189
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on
a clear area. Take care not to lose any parts necessary for
installation.
3. Thread the two studs (S) into the pre-drilled holes in the
mounting plate (M) spaced the same distance apart as the
holes in the back plate (J). Note: The length of studs (S) into
mounting plate (M) may be adjusted if necessary.
4. Attach the mounting plate (M) (Part#A-020) to the outlet box
(not included) with screws (C) (Size: 8-32*1/4”).
5. Align the curved end of scroll arm (K) through the decorative
ring (N) and secure the other end to the back plate (J) with
screw (Q) (Size: M4*10) and hex nut (F).
Fig.1
Set A#: A-020-1
-Mounting plate
-Ground screw
-Mounting screws(2)
CONNECTING ELECTRICAL (Fig.2)
6. Connect the electrical wires as shown in (Fig.2), making
sure that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise, connect the fixture ground wire
directly to the mounting plate using the green screw
provided.
7. Align the fixture to the mounting studs (S) (Size: 8-32*1/2”)
and secure with knurled knobs and washers (B) (Fig1).
8. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. Indoor/Outdoor
Silicone Sealant) to outline the outside off fixture back-plate
where it meets the wall leaving a space at bottom to allow
moisture a means to escape (Fig3).
COMPLETING THE INSTALLATION
9. Separate lamp body (O) from top cover (H) by unscrewing
the mounting screws (G) (Size: M4*16). Align the glass (E)
into body (G) and secure with glass clips (F).
10. Install the 1*60W light bulb (D) in accordance with the
fixtures specification. (DO NOT EXCEED THE
MAXIMUM
WATTAGE
RATING!)(NE
PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
11. Re-attach body (O) to the top cover (H) with mounting
screws (G) (Size: M4*12)
Your installation is now complete. Return power to the junction
box and test the fixture.
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR”
ATTENTION
–
RISQUE
D’INCENDIE,
CONSULTER
UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.
Fig.3
Download PDF