SPT | SL-827N | Use and Care Manual | SPT SL-827N Use and Care Manual

Your Guarantee
If this product is found to be faulty as a result of faulty materials or workmanship
within one year from date of purchase, it will be repaired free of charge.
This guarantee is subject to the following terms:
Sunpentown must be notified of the fault.
Proof of purchase must be presented to Sunpentown’s nominated representative.
The warranty will be void if the product if modified, misused or repaired by an
unauthorized person.
The warranty after repair will not be extended beyond the original one-year period.
All replacement parts will be new or reconditioned.
Parts, which are replaced, become the property of Sunpentown.
The warranty applies for the use of the product in the USA only.
Warranty does not include freight charges.
Incidental or consequential damage caused by possible defects with this product.
Damage to product caused by improper power supply voltage, accident, fire,
floods or acts of nature.
Failure of product resulting from unauthorized modifications to the product.
Improper installation or failure to perform the necessary maintenance.
Desk Lamp (Orange)
This GUARANTEE is in addition to your Statutory Rights
Thank you for your purchase, please read all instructions before using.
Please keep this instruction manual in a safe place for future reference.
Ver.01 DRH-R-84-10
14625 Clark Ave. City of Industry, CA 91745
Tel: 800-330-0388
Do not operate this lamp near a water source to avoid electric shock.
Do not dismantle.
Do not use with power supply other than 120V ~60Hz.
Do not operate lamp in close proximity to flammable or combustible vapors, such
as aerosol spray, or where oxygen is being administered.
Do not cut or shorten the power cord.
Always unplug lamp before performing bulb installation, bulb replacement or
This product may cause interference with radios, cordless telephones or devices
that use a wireless remote control, such as televisions. If interference occurs, move
the product away from the device, plug the device or lamp in a different outlet or
move the lamp out of the line of the remote control receiver.
Unplug the lamp during lightning storms or when unused for extended period of time.
All moisture should be properly wiped away and dried prior to use.
Do not touch bulb when lamp is on or shortly after powering off. May cause burns.
Dispose of bulbs per local regulations.
Press the Power switch to turn on
Press the Power switch again to turn off
Wide lighting distribution, great for studying or work stations.
Flicker free
Bulb has average life span of 6,000 hours.
Simulates natural lighting
Adjustable gooseneck and 350° adjustable lamp shade.
Before cleaning, make sure lamp is powered off and unplugged. Allow sufficient time
for the bulb to cool down.
Periodically wipe the lamp with a soft damp cloth. Use a mild non-abrasive cleaner if
All liquid should be properly wiped away and dried prior to restoring power.
Do not use solvents or abrasive cleaners.
1.Make sure lamp is powered off and unplugged from power source.
2.Firmly hold base and push bulb into the socket.
3.Be sure bulb is firmly seated in the socket and snapped into the metal clip
1.Make sure lamp is powered off and unplugged from power source.
2.Wait until bulb is cool enough to handle.
3.Gently tilt the tip of bulb downwards and remove from metal clip.
4.Firmly hold the bulb base and pull horizontally in an outward motion
Power Consumption
Power Supply
120V / 60Hz
Approx. 15.75x7.48x12.2(in)
2.62 lbs
Replacement Bulb
Download PDF