Minka Lavery | 1961-243 | Installation guide | Minka Lavery 1961-243 Installation Guide

INSTALLATION INSTRUCTION FOR 1961-243
WARNING!
SHUT POWER
OFF AT FUSE OR
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove
old fixture and all hardware from Junction Box.
CIRCUIT BREAKER .
Fig.1
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread the two Studs (A) about 1/4”into the pre-drilled
holes in the mounting strap spaced the same distance
apart as the holes in the fixture canopy (B).
4. Install the mounting strap to the Junction Box with the
two Junction Box Screws as shown. The side of the
mounting strap marked "GND" must face out.
5.
Feed wire through (G), connecting center part (G) to
lamp body (H) and turn clockwise until firmly
tightened.
6.
Feed wire through (F), connecting center part (F) to
center part (G) and turn clockwise until firmly
tightened.
7.
Feed wire through (E), connecting center part (E) to
center part (F) and turn clockwise until firmly
tightened.
8.
Feed wire through (D), connecting center part (D) to
center part (E) and turn clockwise until firmly
tightened.
9. Feed wire through (B), connecting canopy (B) to part
(D) and turn clockwise until firmly tightened.
10. While holding the canopy and lamp cluster towards the
ceiling, connect the electrical wires as Shown in Fig.2,
making sure that all wire connectors are secured. You
may have to wrap the connections with electrical tape.
If there is a Ground Wire (green or bare copper) in your
outlet box, connect the fixture’s Ground Wire to it.
Otherwise connect fixture’s ground wire directly to the
mounting strap with the Green Screw provided. After
wires being connected, tuck them carefully inside the
Junction Box.
11. Then cover the junction box with canopy (B), aligning
the Screw of mounting plate with the hole of canopy
and lock it with brass ball (C).
12. Place Shade (I) onto the socket of fixture body (H) then
secure it in, place with Screw Shell (J) and ring (K)
securely tighten.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)
Download PDF