Minka Lavery | 9142-291 | Installation guide | Minka Lavery 9142-291 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 9141/9142/9143
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Pull black and white wires out of electrical outlet box
(A).
4. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) spaced the same distance
apart as the holes in the back plate (H), then tighten
with the nut (E).
5. Attach circular strap (C) using Outlet Box Screws (F)
to the outlet box (A), (Fig 1).
6. Connect the electrical wires as shown in Fig.2.
Making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s Ground wire to it.
Otherwise, connect the fixture’s Ground wire directly
to the circular strap using the Green Screw (D)
provided.
7. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
8. Place the back plate (H) into stud (B) and secure it
tightly against the wall using cap nut (G). (Fig 1)
9. At this point, unscrew the bottom finial (K) and the
nut (N), remove the bottom holder (J) and the cage
(I) with the shade to install the light bulbs in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!
10. Replace the cage (I) and the bottom holder (J),
secure with the nut (N) and the bottom finial (K).
Screw the top finial (L) by the nipple (M).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig. 1
L
M
A
B
DC
F
E
H
Fig.2
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
BLACK
( HOT)
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
U.S. Patents: D511,396; D512,174;
D512,176; D515,237
This product is protected by United
States Federal and/or State Law,
including Patent and/or Copyright laws.
Download PDF