Minka Lavery | 2931-84-L | Instructions / Assembly | Minka Lavery 2931-84-L Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 2931-L
For LED wall mount fixture
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .
MOUNTING THE FIXTURE (Fig. 1)
1.
2.
3.
Shut off power at the fuse box or circuit breaker box. If
necessary, remove the existing fixture and its mounting
hardware from the wall.
Carefully remove the new fixture from the carton and check
that all parts are included as shown in the illustration.
Attach the mounting plate (A) to the outlet box using outlet
box screws (B) (Size: 8-32*1/2’’L). The side of the
mounting plate marked “GND” must face out.
Fig.1F
CONNECTION THE WIRES (Fig. 2)
4.
At this point, connect the electrical wires as shown in Fig.2,
making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture's ground wire to it. Otherwise, connect
the fixture's ground wire directly to the mounting plate
using the green screw provided. After the wires are
connected, tuck them carefully into the outlet box.
Fig. 2
FINISHING THE INSTALLATION (Fig. 1)
5.
Align Fixture (E) over mounting plate (A) and secure with
screws (D).
Your installation is now complete. Return power to the outlet box
and test the fixture.
CAUTION /ATTENTION: When handling the fixture, do not
apply pressure to the LEDs. Hold the fixture by the base or
fixture body (E) only.
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician
Fig.3
without cutting the wires and without damaging the decorative
element to which the fixture is attached. See installation steps for
more details (Fig 3.)
Warning: Turn off power at the fuse box or circuit
breaker before replacing LED module.
a.
To remove the fixture from the wall: loosen screws (D), and
remove the wire connectors. Then place the fixture on a
clear flat surface.
b.
Loosen screws (P), hex nuts (F) screws (M), wire fastener
(N) and carefully remove the LED module (T).
c.
Reverse steps a-b for installing the new LED module.
Note: The LED module should be provided by a specified
supplier.
IMPORTANT: Fixture should be installed by a
qualified electrician to ensure proper wiring and
installation.
Dimmable with C-L (CFL & LED) type and
Incandescent/Halogen type dimmers
Download PDF