Minka Lavery | 4969-284 | Instructions / Assembly | Minka Lavery 4969-284 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR FIXTURE #4969
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (FIG. 1)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture including the mounting
hardware.
2. Carefully remove the fixture from the carton and check that all
parts are included as shown in the illustration.
3. Thread the nipple (G) into the coupling (H), then secure tightly
with the hex nut.
4. Thread the other hex nut onto the other end of the nipple (G),
then insert the cap (B) over the nipple (G) and secure tightly
with the fixture loop (A).
5. Adjust the fixture arms to their proper position.
6. Place the glass shade (E) over the socket (F), then secure with
the cushion ring (D) and socket ring (C).
7. Install the light bulb in accordance with fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
MOUNTING THE FIXTURE (FIG. 2)
1. Thread the nipple (S) into the collar loop (T) until snug.
2. Thread the other end of nipple (S) into the cross bar (P).
3. Place lock washer (Q) over the end of nipple (S) protruding
through cross bar (P) and thread hex nut (R) onto nipple (S) until
tight.
4. Take this crossbar assembly and mount to ceiling outlet box (V)
using outlet box screw (W) tightly. The side of cross bar marked
“GND” must face out.
5. Use proper chain pliers to open one end link of the chain and
connect to the fixture loop (A). Close the link.
6. By measuring, determine the correct number of links needed for
proper hanging height. Using the chain pliers, disconnect and
discard the remaining chain.
7. Carefully lace the fixture wires through the chain (X).
8. Slip collar ring (Y) over the chain (X), then do the same with
canopy (U).
9. Open the other end link of the chain (X) and connect to the collar
loop (T). Close the link.
10. Feed the fixture wires through the collar loop (T) and nipple (S)
and pull until tight.
CONNECTING THE WIRE (See fig.3)
1. At this point, connect the electrical wires as shown in Fig. 3,
making sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate using the green screw
provided.
2. Tuck these wires connectors neatly into the ceiling out let box
and raise the collar ring (Y) and thread onto collar loop(T)
protruding through canopy.
Fig. 1
(SKT-RING-26)
Fig. 2
Set A#A-010
-Crossbar
-Ground Screw
-Mounting screws (2)
Chain # HCH3072-84
Gauge 4.5MM
Fig.3
Your installation is now complete. Return power to the outlet box
and test the fixture.
Notice: It is important to use proper chain pliers (not
included) to OPEN and CLOSE the chain included with
this fixture. Do not open them with other tools that may
twist or stress the chain links. It is important to use
proper chain pliers like the ones shown in the diagram.
Download PDF