Minka Lavery | 4932-284 | Instructions / Assembly | Minka Lavery 4932-284 Instructions / Assembly

INSTALLATION INSTRUCTION FOR FIXTURE#4932
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (FIG. 1)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture from ceiling, including the
mounting hardware.
2. Carefully remove the fixture from the carton and check that all
parts are included as shown in the illustration.
3. Protrude the nipple with finial (J) through the bottom center
hole of the frame (I), then set aside the frame;
4. Install the glass shade (G) onto the frame (I) by protruding
nipple (I) through the center hole of the glass shade (G) and
secure well with plastic washer (M), flat washer (L) and finial
(K).
5. Assemble the frame (I) onto the upper fixture body by
securing the arms (F) onto the frame (I) using the thumb
screws (H).
6. Install the bulbs in accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
(NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Fig.1
Set A#A-010
-Crossbar
-Ground Screw
-Mounting screws (2)
MOUNTING SCREWS(C)
CANOPY(D)
BALL NUT(E)
THUMB SCREW(H)
ARM(F)
GLASS SHADE(G)
FLAT WASHER(L)
MOUNTING THE FIXTURE (FIG. 2)
7. Attach the cross bar (B) to the outlet box using the outlet box
screws (A). The side of the cross bar marked “GND” must
face out.
8. At this point, connect the electrical wires as shown in figure 2,
making sure that all wire connectors are secured. If your
outlet has a ground wire (green or bare copper), connect the
ground wires from the hanger ball and mounting plate to it.
Otherwise, connect the fixture’s ground wire directly to the
cross bar using the green screw provided. After wires are
connected and secured, tuck them carefully into the ceiling
junction box.
9. Raise the fixture main body to outlet box and attach by
protruding mounting screws(C) through mounting holes on the
canopy (D) and secure with ball nut (E).
Your installation is now complete.
Return power to the junction box to test the fixture.
PLASTIC WASHER(M)
FRAME(I)
Download PDF