Minka Lavery | 1561-477 | Installation guide | Minka Lavery 1561-477 Installation Guide

INSTALLATION INSTRUCTION FOR 1561-477
ARNING! SHUT POWER OFF AT
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove
old fixture and all hardware from Junction Box.
FUSE
OR
CIRCUIT
BREAKER .
Fig.1
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread the two Studs (A) about 1/4”into the pre-drilled
holes in the mounting strap spaced the same distance
apart as the holes in the fixture canopy (B).
4. Install the mounting strap to the Junction Box with the
two Junction Box Screws as shown. The side of the
mounting strap marked "GND" must face out.
5. While holding the canopy and lamp cluster towards the
ceiling, connect the electrical wires as Shown in Fig.2,
making sure that all wire connectors are secured. You
may have to wrap the connections with electrical tape.
If there is a Ground Wire (green or bare copper) in your
outlet box, connect the fixture’s Ground Wire to it.
Otherwise connect fixture’s ground wire directly to the
mounting strap with the Green Screw provided. After
wires being connected, tuck them carefully inside the
Junction Box.
6. Connecting center part (G) to lamp body (H) and turn
clockwise until firmly tightened.
7. Connecting center part (F) to part (G) and turn
clockwise until firmly tightened.
8.
Connecting center part (E) to part (F) and turn
clockwise until firmly tightened.
9.
Connecting center part (D) to part (E) and turn
clockwise until firmly tightened.
10. Connecting canopy (B) to part (D) and turn clockwise
until firmly tightened.
11. Then cover the junction box with canopy (B), aligning
the Screw of mounting plate with the hole of canopy
and lock it with brass ball (C).
12. Hold the glass shade (I) through the lamp body (H), and
then secure the glass shade in. Place by turning the glass
shade in the arrow direction.
13. Install the light bulbs in accordance with the fixture
specifications
NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)
Download PDF