Minka Lavery | 4173-84 | Instructions / Assembly | Minka Lavery 4173-84 Instructions / Assembly

INSTALLATION INSTRUCTION FOR 4173
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DUDISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
ASSEMBLING THE FIXTURE (Fig. 2)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2. Shut off the power at the circuit breaker and remove
Fig.1
old fixture, including the mounting hardware.
HANGING THE FIXTURE (Fig. 1)
3. Thread the nipple (E) into the ceiling loop (H) until snug.
4. Thread hex nut (D) onto nipple (E). Then place lock washer
(C) over end of nipple (E).
5. Thread other end of nipple (E) with loop (H) into mounting
bar (A) until snug.
6. Take the mounting bar (A) assembly and mount to ceiling
junction box with the mounting screws (B) (Size:#832*0.6”L). The side of the mounting bar marked “GND”
must face out.
7. Using proper chain pliers open one link of chain (I) and
connect it to the fixture loop (J).
8. By measuring, determine connect number of links needed
for desired hanging height.
9. Lace the fixture wires through the chain links, and
slip screw collar ring (G) and canopy (F) over the
chain
10. Open one link of the other end of the chain (I) and
connect it to the ceiling loop (H).
11. Feed the fixture wires through the ceiling loop (H) and
nipple (E) and pull until taut.
CONNECTING THE WIRES (Fig. 3)
12. At this point, connect the electrical wires as shown in Fig.
3, making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire directly to the mounting
plate using the green screw provided. After the wires are
connected, tuck them carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig.2)
13. Raise the canopy (F) all the way to the ceiling. Raise the
screw collar ring (G) and thread onto ceiling loop (H)
protruding through canopy (F). (Fig.1)
14. Place the diffuser (V) onto the fixture body (X). Then place
the small steel sheet (W) of the fixture body (X) onto the
diffuser (V).
15. Thread the pipe (P) onto the nipple (Q).
16. Place the hook (M) of the rods (N) onto the loop (O). Then
the loop (L) of the rods (N) onto the hook (K).
17. Install the light bulb(s) in accordance with the fixture’s
specification. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
18. Secure glass panels (T) to iron plate (U) with the screws
(R) and plastic washes (S).
Your installation is now complete. Return the power to the
junction box and test the fixture.
Set# A 012
- Crossbar
- Ground screw
- Mounting screw*2
Chain # HCH2072-84
(4.0mm)
Fig.2
Download PDF