Minka Lavery | 6553-84 | Installation guide | Minka Lavery 6553-84 Installation Guide

INSTALLATION INSTRUCTION FOR FIXTURE 6553-84
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE
1. Shut off the power supply at the fuse box or circuit
breaker box. Remove the old fixture from wall.
Including the old cross bar.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to lose any small
parts necessary for installation.
3. Position mounting plate [B] to the junction box [A] and
secure using the screw [C] ..The side of the mounting
Plate marked “GND” must face out.
4. Follow the wiring instructions carefully (See Fig.2).
5. Attach back plate [D] to the mounting plate [B] and
secure using screw [E]
6. Place three glass shades [G] and three metal rings [H]
on top of socket [F] and secure it with socket ring [I].
7. Install the light bulb in accordance with fixture’s
specifications. DO NOT EXCEED THE MAXMUM
WATTAGE RATING!
Fig. 1
Wiring (See fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black (HOT) house
wire. Connect the white wire from the fixture to the
white (Neutral) house wire. Make sure all the wire
nuts were secured. You may wrap the connections
with electrical tape. If your outlet box has a ground
wire (Green or Bare Copper) connect fixture’s
ground wire to it. Other wise attach the bare copper
fixture wire to the green ground screw on the
mounting plate.
2. Tuck the wire connections neatly into the wall
junction box.
Fig.2
[ I]SOCKET RING
[ H]METAL RING
[ G]GLASS SHADE
[ A]JUNCTION BOX
[ E]SCREW
[ F]SOCKET
[ D]BACK PLATE
[ C]SCREW
[ B]MOUNTING PLATE
Download PDF