Minka Lavery | 4961-84 | Instructions / Assembly | Minka Lavery 4961-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR FIXTURE# 4961
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (FIG. 1)
1. Shut off the power supply at the fuse box or circuit breaker. If
necessary, remove the old fixture from ceiling including the
mounting hardware.
2. Carefully remove the new fixture from the packaging and
check that all parts are included as shown in the illustration.
3. Determine the desired hanging height and thread tubes (H) to
the nipple (I) on the fixture body. Pass the wires carefully
through each tube as you assemble.
4. Then thread the top end of the tubes (H) tightly onto the
nipple (G) on the swivel (F).
5. Put the glass shade (K) over the socket (J) and secure with
cushion ring (L) and socket ring (M).
6. Install the bulbs in accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
(NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
MOUNTING THE FIXTURE (Fig. 1)
7. Attach the cross bar (A) to the outlet box using the outlet box
screws (C). The side of the cross bar marked “GND” must
face out.
8. Follow the wiring instructions carefully (See Fig.2).
9. Attach the fixture main body onto the cross bar (A) by
protruding 2 mounting screws (B) through the mounting holes
of the ceiling canopy (D) and secure with ball nut (E).
CONNECTING THE WIRES (Fig. 2)
1. At this point, connect the electrical wires as shown in figure 2,
making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper), connect
the ground wire from the fixture to it. Otherwise, connect the
fixture’s ground wire directly to the cross bar using the green
screw provided. After wires are connected, tuck them carefully
into the ceiling junction box.
Your installation is now complete. Return power to the outlet
box and test the fixture.
Fig.1
Set A#A-010
-Crossbar
-Ground Screw
-Mounting screws (2)
MOUNTING SCREWS(B)
CANOPY(D)
Rod#W32-1-84
Rod#W30-H-84
SOCKET RING(M)
Download PDF