Minka Lavery 1681-14 Installation Guide

INSTALLATION INSTRUCTIONS
For Model # 1681-14,16-84 (New. 12/18/2002)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove old
fixture from ceiling, including the crossbar.
Fig. 1
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread two Studs (C) about 1/4” into the pre-drilled
holes in the Crossbar (A) spaced the same distance
apart as the holes in the Canopy (D).
4. Attach the Crossbar (A) to the Outlet Box using the
two Screws (B) from the outlet box. The side of the
Crossbar marked “GND” must face out.
CONNECTING THE WIRES (Fig.2)
5. While holding the Light Cluster Assembly (A) towards
the ceiling, connect the electrical wires as shown in
Fig.2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixture's Ground Wire to it.
Otherwise, connect the fixture’s Ground Wire directly
to the Crossbar using the Green Screw provided.
After wires are connected, tuck them carefully into the
ceiling Junction Box.
п оо >
6. Finish hanging the fixture by placing Canopy (D) over
both Studs (C) and secure the Canopy against ceiling
with Knurled Knobs (E).
7. Install the light bulbs in accordance with fixtures
specifications. (CAUTION: Do not exceed the
maximum wattage rating!)
Fig. 2
SHADE INSTALLATION (Fig.1) eur ‘= cucu <
8. Connect all parts of Center Rod (F) together, then Smooth [red Ribbed. [pd
thread it into the bottom coupling of Canopy (D).
9. Thread three Nipples through the holes in the Glass
Shade (H) into Coupling (J).
10. Remove Glass Shade (H) to keep Center Rod (F) in
the center of Glass Shade, and then tighten with Cap
White
(Neutral) (Ground)
Nuts (1).
Your installation is now complete. Return power to the
junction box and test the fixture.
LA-671E