Minka Lavery 1687-14 Installation Guide

 INSTALLATION INSTRUCTIONS
For Model # 1687-14 (New. 01/23/2003)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove old
fixture from ceiling, including the crossbar.
Fig. 1
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small D
parts necessary for installation. : Е
3. Thread two Studs (E) about 1/4” into the pre-drilled CM
holes in the Circular Strap (D) spaced the same
distance apart as the holes in the canopy of Fixture С
Body.
4. Attach the Circular Strap (D) to the Outlet Box (G)
using the two Screws (F). The side of the Circular
Strap marked “GND” must face out.
x
5. Hang the fixture by placing Fixture Body (C) over both
A
Studs (E) and secure Fixture Body against ceiling
with Knurled Knobs (H).
CONNECTING THE WIRES (Fig.2) |
6. While holding the Fixture Body (С) towards the
H
HE
ceiling, connect the electrical wires as shown in Fig.2,
making sure that all wire connectors are secured. If
your outlet has a ground wire (green or bare copper),
connect the fixture’s Ground Wire to it. Otherwise, Fig. 2
connect the fixtures Ground Wire directly to the | |
Circular Strap using the Green Screw provided. After PUE 4e UC
wires are connected, tuck them carefully into the Smooth bed Comper, ка
ceiling Junction Box.
SHADE INSTALLATION (Fig. 1)
7. Install the light bulb in accordance with fixtures
specifications. (CAUTION: Do not exceed the
maximum wattage rating!)
8. Place the Glass Shade (B) into the Shade Frame (A).
9. Attach Shade Frame (A) with Glass Shade (B) inside fenton J
onto the Fixture Body (C) using joints of Fixture Body
as shown in Fig. 1.
HOUSE : HOUSE
WIRES : WIRES
White : Green
(Hot) | (Neutral) : (Ground)
С
american
Your installation is now complete. Return power to the
junction box and test the fixture.
LA-662E