Minka Lavery | 5171-84 | Instructions / Assembly | Minka Lavery 5171-84 Instructions / Assembly

INSTALLATION INSTRUCTION FOR 5171
For Wall Mount Light Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DUDISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture,
including the mounting hardware.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose
any parts necessary for installation.
MOUNTING THE FIXTURE (Fig.1)
3. Secure hanging bracket (A) to outlet box with
junction box screws (B) (Size: #8-32*0.6”L). The
side of the hanging bracket marked “GND” must
face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the fixture wires to the junction box wires
as shown in Fig. 2. Make sure all wire connectors
are secure If there is no green ground wire from
the junction box, connect the fixture ground wire to
the circular strap with the green screw provided.
Tuck these wire connections neatly into the wall
junction box.
COMPLETING THE INSTALLATION
5. Mount the mounting back plate (D) to hanging
bracket (A), and then secure with mounting
screws (C) (Size: #8-32*0.3”L).
6. Place glass (F) over socket (E), then secure with
socket ring (G) by wrench (H).
7. Install the light bulb (I) in accordance with the
fixture’s specifications.
DO NOT EXCEED THE SPECIFIED WATTAGE!
(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Return the power to the junction box and test the
fixture. Your installation is now complete.
Fig.1
Set# A-020-198112
-Hanging bracket
-Ground screw
-Mounting screw*4
-Junction box screws*2
WRH-T1-51
Fig.2
Download PDF