INSTALLATION INSTRUCTIONS Item#1734 (New. 01/21/2011) WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. ASSEMBLY THE FIXTURE (FIG. 1) CONNECTING THE WIRES(FIG.2) 1. Shut off the power supply at the fuse box or 6. At this point, connect the electrical wire as shown in figure 2, making sure that all wire circuit breaker. Remove the old fixture from connectors are secured. If your outlet has a ceiling, including the old cross bar. ground wire (green or bare copper), connect 2. Carefully unpack your new fixture and lay out the fixtures Ground Wire to it. Otherwise, all the parts on a clear area. Take care not to connect the fixture Ground Wire directly to the lose any small parts necessary for mounting plate Ground wires together and secure with wire connectors provided. installation. 3. Attach the Mounting Plate (A) to the Junction box 7. After wires are connected, tuck them carefully using Mounting Screws (B). The side of the into the ceiling junction box, then place Canopy mounting plate with “GND” marked on it must (C) over the Mounting Plate (A) and secure it face out. against ceiling with Screws (D). 4. Determine length desired and thread Bar (F) to 8. Put the glass shade(I)onto socket(H),and nipple (G ), then place the Canopy (C) over the secure it with socket ring(J). Bar (F) and thread the Hanger Ball (E) to Bar (F). 5. While holding the fixture body, install the Hanger COMPLETING THE INSTALLATION (Fig. 1) Ball (E) by tilting Ball at an angle so that it slips 9. Install Light bulbs (not include) in accordance into slot of Mounting Plate (A) as shown. with the fixture’s specifications. (DO NOT Your installation is now complete. Return power to the junction box and test the fixture. Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased. Fig.1 EXCEED THE MAXMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).