Minka Lavery | 1005-44-PL | Installation guide | Minka Lavery 1005-44-PL Installation Guide

INSTALLATION INSTRUCTIONS
For Model #1005-44-PL
W ARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
CAUTION
Turn off the main power at the circuit breaker before installing
the fixture, in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local
and national electrical code (N.E.C) standards. If you are
unfamiliar with proper electrical wiring connections obtain the
services of a qualified electrician.
Remove the fixture and the mounting package from the box
and make sure that no parts are missing by referencing the
illustrations on the installation instruction.
ASSEMBLY AND INSTALLATION
1. Turn off the power.
2. Pull the Supply Wires (3)&(4) and House Ground Wire(2)
out from the Outlet Box(1)
3. Install the Canopy(11)to the Outlet Box(1)by using two
Mounting Screws(13)(Note: The side of the Canopy
marked”GND” must face out)
4. Position your fixture over the Outlet box (1). Mark the
location of the four Slot Holes(14) located on the fixture
body. Remove the fixture body from the ceiling. Drill the
four holes(9)using the appropriately sized drill bit. Insert
the provided ceiling anchors(10) into the holes.
5. Make the wiring connections: Connect the House Ground
Wire (2) to the Fixture Ground Wire(8); connect the White
Supply Wire (3) to the White Fixture Wire (7); connect
Black Supply Wire (4) to the Black Fixture Wire (5) using
Wire Connectors(6). Carefully tuck all wires back into the
Outlet Box.(See Fig.3)
6. Attach the Fixture Pan(22)to the Canopy(11)through the
two Downward Screws(12)and tight it with two Nuts(15)
7. Feed the four Anchor Screws (16) through the Slot Holes.
Tighten the Anchor Screws into the Ceiling Anchors until
the Fixture Body is flush with the ceiling.
8. Install the tube (18). Please follow the wattage label
located on the fixture body. Do not exceed the
recommend wattage.
9. Follow drawing #2 to install the Acrylic Lens (19). Hook
the Clips(21) of the lens to the curve edge of the Fixture
Pan (22 ). (see Figure 2 )
Fig.3
INSTALLATION IS NOW COMPLETED
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
PDF created with pdfFactory Pro trial version www.pdffactory.com
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Download PDF