Minka Lavery | 9149-407 | Installation guide | Minka Lavery 9149-407 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 9149
READ AND SAVE THESE INSTRUCTIONS
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig. 1)
Fig. 1
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur)and remove the old fixture including the
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Unscrew the finial (K) and the nut (L), remove the
bottom holder (J) and the cage (I).
4. Thread the two studs (B) into the pre-drilled holes in
the crossbar (E) (Part#A-010) spaced the same
distance apart as the holes in the canopy (G), and
then tighten with the nuts (C). Note: The length of
studs (B) into crossbar (E) may be adjusted if
necessary.
5. Attach crossbar (E) (Part#A-010) using junction
box screws (D) (Part#8/32”*1”L) to the outlet box (A)
(Fig 1).
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig.2.
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the single bar using the green screw (F)
(Part#8/32”*1/3”L) provided.
COMPLETING THE INSTALLATION (Fig. 1)
Fig.2
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
BLACK
( HOT)
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
7. Align canopy (G) onto stud (B) and secure with cap
nuts (H). (Fig 1)
8. Install 2X60W/E12 bulbs (no bulb included) in
accordance with the fixture specification
—DO
NOT EXCEED THE MAXIMUM WATTAGE
RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
9. Replace the cage (I) and secure with the nut (L),
and replace the bottom holder (J), secure with the
finial (K).
Your installation is now complete. Return power to the
outlet box and test the fixture.
U.S. Patent: D515,237
This product is protected by United
States Federal and/or State Law,
including Patent and/or Copyright laws.
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.
Download PDF