EZ-ON® EZ-ON® Model #543 KidCamTM
KidCam543Instructions11
!
▲
7/19/05
10:29 PM
Page 1
WARNING! DEATH or SERIOUS INJURY can occur if
manufacturer’s instructions are not followed correctly.
E-Z-ON®
Model #543
KidCam
TM
cam strap adjuster
snap hook
for School Buses
o-bracket
Y-bridge
• Use on a school bus seat only.
harness
adjusters
• Meets FMVSS213.
• Use for a passenger weighing
30-80 lbs.
height adjuster
• You must use this KidCam™
restraint with a school bus
lap belt.
harness
straps
• Replace after a crash or
5 years from the date of
manufacture.
adjustable
crotch straps
• Crotch straps are not
needed when used with a
booster.
cam strap
• Be sure to register this
restraint to be notified of
a safety recall.
2-piece
chest
clip
• Passengers seated behind
occupants in KidCam™
must be restrained with a
seatbelt or other restraint,
or the seat be unoccupied.
loop ends for
school bus
lap belt
E-Z-ON®
Products, Inc. of Florida
605 Commerce Way West • Jupiter, FL 33458
800-323-6598/561-747-6920 • Fax 561-747-8779 • www.ezonpro.com
© 2005 E-Z-ON®
KidCam543Instructions11
7/19/05
E-Z-ON®
Model #543
KidCam
10:29 PM
Page 2
2
Y-bridge
front of
bus seat
TM
shoulder
adjusters
for School Buses
Installation Guide
for School Buses
chest
clip
Bus seats must have seatbelts
and access between the seat
cushion and seat back to install.
Step 1
Attaching the KidCam™ to the
school bus seat for passengers
weighing 30-80 lbs.
1. Unlock the bus seat and
lift up.
lap
belt
crotch straps
3
2. Place the Y-bridge on the
seat top ;
a. rest black shoulder
straps on the front of
the bus seat,
b. allow crotch straps to
pass through the seat
opening to rest on the
bus seat. Close and lock
the bus seat.
3. Wrap the gray cam strap
around the bus seat:
a. lower the o-bracket over
the back of the bus seat,
b. pass the snap hook
through the front seat
opening.
gray cam
strap
shoulder
straps
4
tightness
crease
harness
height
adjuster
o-bracket
o-bracket
snap hook
gray
cam strap
adjuster
gray
webbing end
crotch strap
adjuster
snap
hook
velcro
tab
back of
bus seat
5
side view
4. Attach the snap hook onto
the o-bracket.
5. Secure the gray cam strap:
a. press the spring lock,
b. pull gray webbing end
snug,
c. create a crease on top
of the bus seat.
gray cam
strap adjuster
gray
webbing end
KidCam543Instructions11
7/19/05
Step 2
Securing the Passenger:
10:29 PM
Page 3
1
2
Be sure the passenger sits
upright with buttocks against
the seat back.
1. Place harness straps over
each shoulder.
2. Locate the crotch straps
in the center of the
passenger’s legs.
3. 1st thread lap belt through
the 1st crotch loop, 2nd
through the 1st harness
loop, 3rd through the last
harness loop and 4th
through the last crotch loop.
3
4
1st
2nd
4. Buckle lap belt low across
the lap. Reduce lap belt
slack.
5. If using a booster no crotch
straps are necessary
according to NHTSA
regulations. Thread lap belt
through both harness loops
and keep lap belt under
booster arms. Reduce lap
belt slack.
4th
3rd
!
▲
WARNING! Failure to thread the crotch
straps like this could cause injury.
Step 3
Harness Adjuster
Step 3
Adjusting the Harness
Straps on the passenger:
adjuster
release
1. To shorten harness straps:
Press the spring-locks on
each harness adjuster. Pull
loose ends of webbing to
shorten.
shorten
2. To lengthen harness straps:
Press the spring-locks on
each harness adjuster. Pull
harness loop ends (lap belt
is threaded through these)
downward, to lengthen.
3. Keep both adjusters at the
same height on the passenger.
loop end
!
▲
lengthen
WARNING! DO NOT shorten harness
length to much. This could pull lap belt
up, over stomach and cause injury. Harness
should fit securely without slack. Some seat
belts have long fixed (female)ends. NHTSA
recommends 7.5 inch fixed belt ends for best fit.
A booster helps keep lap belt low when seat
belt fixed ends are too long.
KidCam543Instructions11
Step 4
7/19/05
harness
height
adjuster
o-bracket
crotch
staps
Step 5
back of bus seat
front of bus seat
Step 6
Step 7
10:29 PM
Page 4
Step 4
Adjusting the Harness Height Adjuster on passenger.
Keep both harness adjusters even on passenger.
1. Adjust harness height by sliding Y-bridge on gray
cam strap.
2. Harness height adjuster is attached to gray cam
strap above the o-bracket.
3. Press spring-lock on height adjuster:
a. pull black webbing end to shorten harness height,
b. pull harness to lengthen harness height.
Step 5
Adjusting the crotch straps
1. Adjust crotch straps snug but not too tight.
2. Press spring-lock on crotch strap adjuster:
a. pull black webbing end to shorten straps,
b. pull harness to lengthen straps.
Step 6
Adjusting velcro-tab
1. Roll-up webbing ends on the height adjuster, the
crotch strap adjuster and the cam adjuster.
2. Secure the velcro-tab.
Step 7
Adjusting the chest clip
1. Squeeze male end to fit in the female end to secure.
a. Squeeze the male end to release.
b. Keep the clip below the harness adjusters at
arm-pit level.
How to Register This Child Restraint
Child restraints could be recalled for safety reasons.
You must register this restraint in order to be notified of a recall.
Fill out the REGISTRATION CARD enclosed with your E-Z-ON® Harness,
send your name address and the restraint model number and manufacturing date to
the address below or log on to our website www.ezonpro.com
and fill out your product information via our registration page.
For recall information, call the U.S. Government Auto Safety Hotline at
1 (800) 424-9393. In the Washington D.C. area call (202) 366-0123.
E-Z-ON®
Products, Inc. of Florida
605 Commerce Way West • Jupiter, FL 33458
800-323-6598/561-747-6920 • Fax 561-747-8779 • www.ezonpro.com
© 2005 E-Z-ON®
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement