Minka Lavery | 4176-84 | Instructions / Assembly | Minka Lavery 4176-84 Instructions / Assembly

INSTALLATION INSTRUCTION FOR 4176
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
ASSEMBLING THE FIXTURE (Fig. 2)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2. Shut off the power at the circuit breaker and remove old
fixture, including the mounting hardware.
3. Spread the arms (N) so that the arms (N) are at equal
distance from each other.
4. Thread the center column assembly nipple (K) through the
tube (L) onto the coupling (M) and secure with the nipple
(K).
HANGING THE FIXTURE (Fig. 1)
5. Thread the nipple (E) into the ceiling loop (H) until snug.
6. Thread hex nut (D) onto nipple (E). Place lock washer (C)
over end of nipple (E)
7. Thread other end of nipple (E) with loop attached into
crossbar (A) until snug.
8. Take this crossbar (A) assembly and mount to ceiling
junction box with mounting box screws (B) (Size: #832*0.6”L). The side of the mounting bar marked “GND”
must face out.
9. Using proper chain pliers open one link of chain (I) and
connect it to the fixture loop (J).
10. By measuring, determine connect number of links needed
for desired hanging height.
11. Lace the fixture wires through the chain links and slip
screw collar ring (G) and the canopy (F) over the chain.
12. Open one link of the other end of the chain (I) and connect
it to the ceiling loop (H).
13. Feed the fixture wires through the ceiling loop (H) and
nipple (E) and pull until taut.
CONNECTING THE WIRES (Fig. 3)
14. At this point, connect the electrical wires as shown in Fig.
3, making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire directly to the mounting
plate using the green screw provided. After the wires are
connected, tuck them carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig.2)
15. Raise the canopy (F) all the way to the ceiling. Raise the
screw collar ring (G) and thread onto ceiling loop (H)
protruding through canopy (F). (Fig.1)
16. Install the light bulb(s) in accordance with the fixture’s
specification. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return the power to the
junction box and test the fixture.
Fig.1
Set# A 012
- Crossbar
- Ground screw
- Mounting screw*2
Set# A 012
- Crossbar
- Ground screw
- Mounting screw*2
Chain # HCH2072-84
HCH2072-249
C hain # (4.0mm)
(4.0mm)
Fig.2
CCV22120P-84
Download PDF